Search results
Results From The WOW.Com Content Network
In these conditions, the actual evapotranspiration would match the Penman rate of potential evapotranspiration. However, observations revealed that actual evaporation was 1.26 times greater than potential evaporation, and therefore the equation for actual evaporation was found by taking potential evapotranspiration and multiplying it by α ...
Potential evapotranspiration is expressed in terms of a depth of water or soil moisture percentage. If the actual evapotranspiration is considered the net result of atmospheric demand for moisture from a surface and the ability of the surface to supply moisture, then PET is a measure of the demand side (also called evaporative demand).
It is a steel container 1.83 m (6 ft) on a side and 0.61 m (2 ft) deep, sunk into the ground with an above-ground rim of 7.6–10 centimetres (3.0–3.9 in) and is painted black internally. Its evaporation rate is lower than the Class A pan and conversion factors must be used. [8]
E = Mass water evapotranspiration rate (g s −1 m −2) ET = Water volume evapotranspired (mm s −1) Δ = Rate of change of saturation specific humidity with air temperature. (Pa K −1) R n = Net irradiance (W m −2), the external source of energy flux G = Ground heat flux (W m −2), usually difficult to measure
Specifically the Penman–Monteith equation refines weather based potential evapotranspiration (PET) estimates of vegetated land areas. [1] It is widely regarded as one of the most accurate models, in terms of estimates. [citation needed] The original equation was developed by Howard Penman at the Rothamsted Experimental Station, Harpenden, UK.
Inputs to SPEI datasets can include high-resolution potential evapotranspiration (PET) from the Global Land Evaporation Amsterdam Model (GLEAM) and hourly Potential Evapotranspiration (hPET). GLEAM is a set of algorithms designed to calculate actual evaporation, PET, evaporative stress, and root-zone soil moisture. [5]
Drier surroundings give a steeper water potential gradient, and so increase the rate of transpiration. Wind: In still air, water lost due to transpiration can accumulate in the form of vapor close to the leaf surface. This will reduce the rate of water loss, as the water potential gradient from inside to outside of the leaf is then slightly less.
Vapor pressure of water vs. temperature. 760 Torr = 1 atm. If evaporation takes place in an enclosed area, the escaping molecules accumulate as a vapor above the liquid. Many of the molecules return to the liquid, with returning molecules becoming more frequent as the density and pressure of the vapor increases.