Ads
related to: hard wire computer to modem
Search results
Results From The WOW.Com Content Network
A dial-up modem transmits computer data over an ordinary switched telephone line that has not been designed for data use. It was once a widely known technology, mass-marketed globally dial-up internet access. In the 1990s, tens of millions of people in the United States alone used dial-up modems for internet access.
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
The modem connects to a single computer or router, through an Ethernet port, USB port, or is installed in a computer PCI slot. The more common DSL router is a standalone device that combines the function of a DSL modem and a router, and can connect multiple computers through multiple Ethernet ports or an integral wireless access point.
Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure everything was reset. Just wait about five minutes before turning it back on to make sure everything was reset.
Data Terminal Ready (DTR) is a control signal in RS-232 serial communications, transmitted from data terminal equipment (DTE), such as a computer, to data communications equipment (DCE), for example a modem, to indicate that the terminal is ready for communications and the modem may initiate a communications channel.
Terminal adapter for X.21 Two data stations (terminals, stations) each comprising a DCE and a DTE, connected via a network.. A data circuit-terminating equipment [1] (DCE) is a device that sits between the data terminal equipment (DTE) and a data transmission circuit.