When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Serpentine belt - Wikipedia

   en.wikipedia.org/wiki/Serpentine_belt

   Serpentine belt (foreground) and dual vee belt (background) on a bus engine Belt tensioner providing pressure against the back of a serpentine belt in an automobile engine. A serpentine belt (or drive belt [1]) is a single, continuous belt used to drive multiple peripheral devices in an automotive engine, such as an alternator, power steering pump, water pump, air conditioning compressor, air ...

3. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

4. Timing belt (camshaft) - Wikipedia

   en.wikipedia.org/wiki/Timing_belt_(camshaft)

   The main disadvantage is that belts wear over time, therefore belt replacement is recommended at specific intervals. [5] [6] Replacement of the engine's water pump at the same time is often recommended, since the water pump is also subject to wear and easily accessed during the replacement of the timing belt.

5. Toothed belt - Wikipedia

   en.wikipedia.org/wiki/Toothed_belt

   Toothed belts are used widely in mechanical devices, including sewing machines, photocopiers and many others. A major use of toothed belts is as the timing belt used to drive the camshafts within an automobile or motorcycle engine. As toothed belts can deliver more power than a friction-drive belt, they are used for high-power transmissions.

6. Ford Mondeo (second generation) - Wikipedia

   en.wikipedia.org/wiki/Ford_Mondeo_(second...

   In Mexico, the model was similar to the European version to replace the Ford Contour. Trim levels were Core, Edge, Ghia and 100 units of the ST220 (sold as a limited edition), it was sold only with the 2.0 4-cylinder, 2.5 V6 and 3.0 V6 (for the ST220) petrol: no turbodiesel or estate versions were available in Mexico

7. Ford small block engine - Wikipedia

   en.wikipedia.org/wiki/Ford_small_block_engine

   The block mount pads and the cylinder wall contour of the 221 and 260 engines changed in January–February 1963 with the introduction of the 289 variant – all 221 and 260 engine blocks up to this time featured "corrugated wall" construction with two core plugs on the side of each bank and engine mount hole pitch distances of 6 inch.