Search results
Results From The WOW.Com Content Network
When reading from memory, data addressed by MAR is fed into the MDR (memory data register) and then used by the CPU. When writing to memory, the CPU writes data from MDR to the memory location whose address is stored in MAR. MAR, which is found inside the CPU, goes either to the RAM (random-access memory) or cache.
Memory-mapped I/O is preferred in IA-32 and x86-64 based architectures because the instructions that perform port-based I/O are limited to one register: EAX, AX, and AL are the only registers that data can be moved into or out of, and either a byte-sized immediate value in the instruction or a value in register DX determines which port is the source or destination port of the transfer.
In a computer using virtual memory, accessing the location corresponding to a memory address may involve many levels. In computing, a memory address is a reference to a specific memory location in memory used by both software and hardware. [1] These addresses are fixed-length sequences of digits, typically displayed and handled as unsigned ...
In computer science, a data buffer (or just buffer) is a region of memory used to store data temporarily while it is being moved from one place to another. Typically, the data is stored in a buffer as it is retrieved from an input device (such as a microphone) or just before it is sent to an output device (such as speakers); however, a buffer may be used when data is moved between processes ...
An address bus is a bus that is used to specify a physical address. When a processor or DMA-enabled device needs to read or write to a memory location, it specifies that memory location on the address bus (the value to be read or written is sent on the data bus). The width of the address bus determines the amount of memory a system can address.
Unlike standard computer memory, random-access memory (RAM), in which the user supplies a memory address and the RAM returns the data word stored at that address, a CAM is designed such that the user supplies a data word and the CAM searches its entire memory to see if that data word is stored anywhere in it. If the data word is found, the CAM ...
The DMA command is issued by specifying a pair of a local address and a remote address: for example when a SPE program issues a put DMA command, it specifies an address of its own local memory as the source and a virtual memory address (pointing to either the main memory or the local memory of another SPE) as the target, together with a block size.
Decoding the op-code in the instruction register includes determining the instruction, determining where its operands are in memory, retrieving the operands from memory, allocating processor resources to execute the command (in super scalar processors), etc.