Ads
related to: typical flat roof thickness height table size chart cm inches to mm
Search results
Results From The WOW.Com Content Network
A flat roof is a roof which is almost level in contrast to the many types of sloped roofs. The slope of a roof is properly known as its pitch and flat roofs have up to approximately 10°. [1] Flat roofs are an ancient form mostly used in arid climates and allow the roof space to be used as a living space or a living roof. Flat roofs, or "low ...
Satari: A Swedish variant on the monitor roof; a double hip roof with a short vertical wall usually with small windows, popular from the 17th century on formal buildings. [citation needed] (Säteritak in Swedish.) Mansard (French roof): A roof with the pitch divided into a shallow slope above a steeper slope. The steep slope may be curved.
Historically, roof pitch was designated in two other ways: A ratio of the ridge height to the width of the building (span) [6] and as a ratio of the rafter length to the width of the building. [7] Commonly used roof pitches were given names such as: Greek: the ridge height is 1 ⁄ 9 to 1 ⁄ 7 the span (an angle of 12.5° to 16°);
The load tables use the code to identify double tee span type by using the width in feet, followed by "DT", followed by depth in inches, for example, 4DT14 is for 4-foot (1.2 m) wide, 14-inch (36 cm) deep double tees. In its first publication there were seven double tee types from 4DT14 to 10DT32.
In Scandinavia shakes, traditionally used only for roofing, are generally smaller than in North America, measuring 13–16 inches (330–410 mm) long, 4–6 inches (100–150 mm) wide and 1 ⁄ 8 inch (3.2 mm) thick, [6] while in Poland and Slovakia they are usually 36 inches (910 mm) long, 4–6 inches (100–150 mm) wide and 1–1.25 inches ...
In the UK, a concrete tiled roof would normally have rafters at 600 mm (24 in) centers, roof battens at 300 mm (12 in) centers and ceiling joists at 400 mm (16 in) centers. The United States still uses imperial units of measurement and framing members are typically spaced sixteen or twenty-four inches apart.
Installation is very streamlined and a rapid process. Depending on the size of the roof and the experience of the crew, it is possible to remove old shingles and apply new ones on 2-3 houses in one day. Life span varies. Use only on slanted roofs. [4] Rubber shingle, an alternative to asphalt shingle, slate, shake or tile.
Structural clay tiles are manufactured in a variety of standard sizes, including 4 inches (10 cm), 6 inches (15 cm), 8 inches (20 cm), 10 inches (25 cm) and 12 inches (30 cm)thicknesses, and typically 12 inches (30 cm) x 12 inches (30 cm) or 12 inches (30 cm) x 8 inches (20 cm) face dimensions. [5]