Search results
Results From The WOW.Com Content Network
An engine control unit (ECU), also called an engine control module (ECM), [1] is a device that controls various subsystems of an internal combustion engine. Systems commonly controlled by an ECU include the fuel injection and ignition systems.
An ECU from a Geo Storm. An electronic control unit (ECU), also known as an electronic control module (ECM), is an embedded system in automotive electronics that controls one or more of the electrical systems or subsystems in a car or other motor vehicle.
Featured on both the intake and exhaust camshafts, each can be varied through a range of 40 degrees. The twin spark plug system was replaced by a regular single spark plug per cylinder. New electronic coolant flow control has replaced the mechanical thermostat for improved engine warm-up and optimum control of engine temperature.
The way they do this is during a deceleration of the vehicle when there is low absolute pressure in the intake manifold (i.e., a high vacuum present in the intake manifold relative to the outside air) the powertrain control module (PCM) will open the EGR valve and then monitor the MAP sensor's values. If the EGR is functioning properly, the ...
Fault Recovery in FDIR is the action taken after a failure has been detected and isolated to return the system to a stable state. Some examples of fault recoveries are: Switch-off of a faulty equipment; Switch-over from a faulty equipment to a redundant equipment; Change of state of the complete system into a Safe Mode with limited functionalities
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
The first sign of crankshaft sensor failure, usually, is the refusal of the engine to start when hot but will start again once the engine has cooled. One detail of some designs is the "three-wire" inductive crank sensor whereby the third wire is actually just a co-axial shield around the two main sensor wires to prevent them from picking up ...
The solenoid valve regulates the amount of oil pumped by the cam action to either the valve or a bypass reservoir. When pressurized, the hydraulic line behaves like a solid body and transmits the lift schedule imparted by the intake cam directly to the intake valve. When the solenoid is disengaged, a spring takes over valve actuation duties.