When.com Web Search

  1. Ads

    related to: direct bury 12 gauge wire

Search results

  1. Results From The WOW.Com Content Network
  2. Direct-buried cable - Wikipedia

    en.wikipedia.org/wiki/Direct-buried_cable

    Cross-section of direct buried cable. Direct-buried cable (DBC) is a kind of communications or transmissions electrical cable which is especially designed to be buried under the ground without any other cover, sheath, or duct to protect it. [1] Most direct-buried cable is built to specific tolerances to heat, moisture, conductivity, and soil ...

  3. Thermoplastic-sheathed cable - Wikipedia

    en.wikipedia.org/wiki/Thermoplastic-sheathed_cable

    If the label says "12-3", this cable has four conductors—three 12-gauge insulated wires and a bare copper ground wire. [ 5 ] Different types of cables are approved for different applications; the cable used for interior wiring in dry locations is different from the types approved for underground burial, direct embedment in concrete, or ...

  4. Power cable - Wikipedia

    en.wikipedia.org/wiki/Power_cable

    Modern two or three-wire+ground PVC-insulated cable (e.g., NM-B), produced by such brands as Romex [citation needed] Aluminum wire was used in the 1960s and 1970s as a cheap replacement for copper and is still used today, but this is now considered [by whom?] unsafe, without proper installation, due to corrosion, softness and creeping of ...

  5. Underground power line - Wikipedia

    en.wikipedia.org/wiki/Underground_power_line

    The lifetime cost difference is smaller for lower-voltage distribution networks, in the range of 12–28% higher than overhead lines of equivalent voltage. [12] Whereas finding and repairing overhead wire breaks can be accomplished in hours, underground repairs can take days or weeks, [13] and for this reason redundant lines are run.

  6. Electrical wiring in North America - Wikipedia

    en.wikipedia.org/wiki/Electrical_wiring_in_North...

    In both those instances the white wire should be identified as being hot, usually with black tape inside junction boxes. The neutral wire is identified by gray or white insulated wire, perhaps using stripes or markings. With lamp cord wire the ribbed wire is the neutral, and the smooth wire is the hot. NEC 2008 400.22(f) allows surface marking ...

  7. Electrical wiring - Wikipedia

    en.wikipedia.org/wiki/Electrical_wiring

    The first rubber-insulated cables for US building wiring were introduced in 1922 with US patent 1458803, Burley, Harry & Rooney, Henry, "Insulated electric wire", issued 1923-06-12, assigned to Boston Insulated Wire and Cable . These were two or more solid copper electrical wires with rubber insulation, plus woven cotton cloth over each ...