Ads
related to: hacks for hiding computer wires and connectors free patterns made
Search results
Results From The WOW.Com Content Network
Ribbon cable with three connectors. Ribbon cables are usually specified by two numbers: the spacing or pitch of the conductors, and the number of conductors or ways. A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm).
Example of a complicated circuit made in WireWorld: a seven-segment display and decoder. Conductor cells are dark green to highlight signal flow and display segments. A Wireworld cell can be in one of four different states, usually numbered 0–3 in software, modeled by colors in the examples here: empty (black), electron head (blue),
These wires are called wire bridges or jumpers, but unlike jumpers used for configuration settings, they are intended to permanently connect the points in question. They are used to solve layout issues of the printed wiring, providing connections that would otherwise require awkward (or in some cases, impossible) routing of the conductive traces.
Cable lacing is a method for tying wiring harnesses and cable looms, traditionally used in telecommunication, naval, and aerospace applications. This old cable management technique, taught to generations of lineworkers , [ 1 ] is still used in some modern applications since it does not create obstructions along the length of the cable, avoiding ...
Manual wire wrapping/stripping tool. A correctly made wire-wrap connection for 30 or 28 AWG wire is seven turns (fewer for larger wire) of bare wire with half to one and a half turns of insulated wire at the bottom for strain relief. [3] [4] The square hard-gold-plated post thus forms 28 redundant contacts. The silver-plated wire coating cold ...
Thunderbolt (interface) also supports daisy-chained devices such as RAID arrays and computer monitors. [3] DisplayPort 1.2 and higher features Multi-Stream Transport (MST) mode. In this mode, multiple screens can be connected either using a hub or as a daisy chain. The Hexbus is the 10-wire bus of Texas Instruments, used in the TI-99/4A, CC-40 ...
Discover the best free online games at AOL.com - Play board, card, casino, puzzle and many more online games while chatting with others in real-time.
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.