Ads
related to: powered subwoofer wiring diagram
Search results
Results From The WOW.Com Content Network
For a given output voltage swing, the lower the impedance the higher the amplifier load. Bridging is used to allow an amplifier to drive low loads into higher power, because power is inversely proportional to impedance and proportional to the square of voltage, according to the equation = /. This equation also shows that bridging quadruples the ...
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
From about 1900 to the 1950s, the "lowest frequency in practical use" in recordings, broadcasting and music playback was 100 Hz. [9] When sound was developed for motion pictures, the basic RCA sound system was a single 8-inch (20 cm) speaker mounted in straight horn, an approach which was deemed unsatisfactory by Hollywood decisionmakers, who hired Western Electric engineers to develop a ...
The term loudspeaker may refer to individual transducers (also known as drivers) or to complete speaker systems consisting of an enclosure and one or more drivers.. To adequately and accurately reproduce a wide range of frequencies with even coverage, most loudspeaker systems employ more than one driver, particularly for higher sound pressure level (SPL) or maximum accuracy.
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
The grids must be able to generate as uniform an electric field as possible, while still allowing for sound to pass through. Suitable grid constructions are therefore perforated metal sheets, a frame with tensioned wire, wire rods, etc. To generate a sufficient field strength, the audio signal on the grids must be of high voltage.