Search results
Results From The WOW.Com Content Network
For s polarization, the reflection coefficient r is defined as the ratio of the reflected wave's complex electric field amplitude to that of the incident wave, whereas for p polarization r is the ratio of the waves complex magnetic field amplitudes (or equivalently, the negative of the ratio of their electric field amplitudes).
The Stokes I, Q, U and V parameters. The Stokes parameters are a set of values that describe the polarization state of electromagnetic radiation.They were defined by George Gabriel Stokes in 1851, [1] [2] as a mathematically convenient alternative to the more common description of incoherent or partially polarized radiation in terms of its total intensity (I), (fractional) degree of ...
In comparison with lower frequencies such as microwaves, the amount of angular momentum in light, even of pure circular polarization, compared to the same wave's linear momentum (or radiation pressure) is very small and difficult to even measure. However, it was utilized in an experiment to achieve speeds of up to 600 million revolutions per ...
For a general input polarization, the net effect of the rhomb is identical to that of a birefringent (doubly-refractive) quarter-wave plate, except that a simple birefringent plate gives the desired 90° separation at a single frequency, and not (even approximately) at widely different frequencies, whereas the phase separation given by the rhomb depends on its refractive index, which varies ...
Polarizability is responsible for a material's dielectric constant and, at high (optical) frequencies, its refractive index. The polarizability of an atom or molecule is defined as the ratio of its induced dipole moment to the local electric field; in a crystalline solid, one considers the dipole moment per unit cell . [ 1 ]
Brewster's angle is often referred to as the "polarizing angle", because light that reflects from a surface at this angle is entirely polarized perpendicular to the plane of incidence ("s-polarized"). A glass plate or a stack of plates placed at Brewster's angle in a light beam can, thus, be used as a polarizer.
Any S-parameter may be displayed graphically on a polar diagram by a dot for one frequency or a locus for a range of frequencies. If it applies to one port only (being of the form S n n {\displaystyle S_{nn}\,} ), it may be displayed on an impedance or admittance Smith Chart normalised to the system impedance.
In the example figure at top of this page, it can be seen that refracted ray with s polarization (with its electric vibration along the direction of the optic axis, thus called the extraordinary ray [7]) is the slow ray in given scenario. Using a thin slab of that material at normal incidence, one would implement a waveplate. In this case ...