Ad
related to: water vapor levels in winter garden areaefireplacestore.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
Using the classical definition of advection, moisture advection is defined as: =in which V is the horizontal wind vector, and is the density of water vapor. However, water vapor content is usually measured in terms of mixing ratio (mass fraction) in reanalyses or dew point (temperature to partial vapor pressure saturation, i.e. relative humidity to 100%) in operational forecasting.
Water vapor can also be indirect evidence supporting the presence of extraterrestrial liquid water in the case of some planetary mass objects. Water vapor, which reacts to temperature changes, is referred to as a 'feedback', because it amplifies the effect of forces that initially cause the warming. Therefore, it is a greenhouse gas. [2]
Frost forms when the air contains more water vapor than it can normally hold at a specific temperature. The process is similar to the formation of dew, except it occurs below the freezing point of water typically without crossing through a liquid state. Air always contains a certain amount of water vapor, depending on temperature.
Humidity depends on the temperature and pressure of the system of interest. The same amount of water vapor results in higher relative humidity in cool air than warm air. A related parameter is the dew point. The amount of water vapor needed to achieve saturation increases as the temperature increases.
On one hand, houseplants grow slower in winter and generally need less water at this time; however, leaves are more likely to be damaged by dry indoor air when fireplaces and heating units are ...
Preferred weather conditions include the absence of clouds and little water vapor in the higher atmosphere to minimize greenhouse effects and sufficient humidity of the air near the ground. Typical dew nights are classically considered calm, because the wind transports (nocturnally) warmer air from higher levels to the cold surface.
The Wegener–Bergeron–Findeisen process (after Alfred Wegener, Tor Bergeron and Walter Findeisen []), (or "cold-rain process") is a process of ice crystal growth that occurs in mixed phase clouds (containing a mixture of supercooled water and ice) in regions where the ambient vapor pressure falls between the saturation vapor pressure over water and the lower saturation vapor pressure over ice.
The main ways water vapor is added to the air are: wind convergence into areas of upward motion, [12] precipitation or virga falling from above, [24] daytime heating evaporating water from the surface of oceans, water bodies or wet land, [25] transpiration from plants, [26] cool or dry air moving over warmer water, [27] and lifting air over ...