Ads
related to: phoenix connector 12 pin plug on bumper pull truck
Search results
Results From The WOW.Com Content Network
The connectors are designed for 12V systems. Exceptions for the 7-pin connector may exist where they may be used for 6V and 24V. Vehicles and trailers with 6V systems can use the 7-pin or a 5-pin connector, but these are rare today. Heavy trucks that may have 12V systems are usually older (vintage vehicles) or on non-European markets. [1]
Trailer connector according to NATO STANAG 4007. NATO uses a 12-pin connector [NATO 1] [NATO 2] according to STANAG 4007. [1] However, note that there are often deviations from the standard depending on which country it is applied, which means that the table below may not be accurate.
4-pin round connector (Towing vehicle side) This connector is available in some cases instead of the flat 4-pin connector. It is less common on the U.S.-built vehicles, than 4-pin flat connector, but is still used in the older truck and SUV setups.
A trailer connector is a multi-pole electrical connector between a towing vehicle (car, truck) and a trailer. It is intended primarily to supply automotive lighting on the trailer, but also provide management and supply to other loads. It is also referred to as "trailer wire," "trailer cable," or "trailer connecting cable."
Ground for pin 9 [a] ISO 11446:2004 specifies a 13-pole electrical connector between towing and towed vehicles with 12 volt electrical system . It was developed in 1987 by Erich Jaeger [ 1 ] to replace older 7-pin plugs.
Multicon [1] Feder and Multicon WeSt (Welt Standard) connectors are precursors to ISO 11446 in a design that is intended to be compatible with ISO 1724.This means that if a towing vehicle has an outlet of this type it should be able to connect a trailer with a standard 7-pin or 5-pin connector according to ISO 1724, provided that the trailer coupling follows the standard and that the trailer ...
Ad
related to: phoenix connector 12 pin plug on bumper pull truck