Ad
related to: pneumatic tire rolling resistance ratings calculatortirerack.com has been visited by 100K+ users in the past month
- Shop By Vehicle
Find a Wide Selection
for Your Make and Model!
- Shop by Tire Size
The Perfect Fit - Exactly
What You Are Looking For!
- Tire Decision Guide
The Right Tires
in 2 Minutes or Less!
- All-Season Tires
Tires for Enhanced
Handling All Year Long!
- Shop By Vehicle
Search results
Results From The WOW.Com Content Network
SAE J1269 and SAE J2452 performed on new tires. SAE J2452 is a standard defined by the Society of Automotive Engineers [1] to measure the rolling resistance of tires. [2] Where the older standard, SAE J1269, produces measurements of rolling resistance under steady-state (i.e. thermally equilibrated) operating conditions, SAE J2452 produces measurements during a transient history of speed that ...
Rolling resistance, sometimes called rolling friction or rolling drag, is the force resisting the motion when a body (such as a ball, tire, or wheel) rolls on a surface. It is mainly caused by non-elastic effects; that is, not all the energy needed for deformation (or movement) of the wheel, roadbed, etc., is recovered when the pressure is removed.
Starting in 1972 tires were specified by load rating, using a letter code. In practice, a higher load rating tire was also a wider tire. In this system a tire had a letter, optionally followed by "R" for radial tires, followed by the aspect ratio, a dash and the diameter – C78-15 or CR78-15 for bias and radial, respectively. Each diameter of ...
These coefficients are measured on rollers, with power meters on road surfaces, or with coast-down tests. In the latter two cases, the effect of air resistance must be subtracted or the tests performed at very low speeds. In 2009 The CEC used a rating called Rolling Resistance Force RRF. RRF and RRC, rolling resistance coefficient are very similar.
In a non-scientific study (I looked at tires available from a national chain that fit my car), 85 percent of LRR tires had an “A” rating for traction, compared to 87 percent of Non-LRR tires.
SAE J1269 is a standard test defined by the Society of Automotive Engineers [1] to measure the rolling resistance of tires under conditions of thermal equilibrium. [2] [3] SAE J2452 is an alternative procedure for measuring rolling resistance under conditions similar to a vehicle coastdown event, where the tire is in a roughly isothermal condition (but not thermal equilibrium).
Rolling resistance is the main key factor in measuring the energy efficiency of a tyre and has direct influence on the fuel consumption of a vehicle. A set of tyres of the green class "A" compared to a "G" class can reduce fuel consumption by 9% [3] of a passenger car; even more for trucks.
Pneumatic tires also have a much lower rolling resistance than solid tires. Because the internal air pressure acts in all directions, a pneumatic tire is able to "absorb" bumps in the road as it rolls over them without experiencing a reaction force opposite to the direction of travel, as is the case with a solid (or foam-filled) tire. [26]