Ad
related to: r22 low pressure temperature chart automotive
Search results
Results From The WOW.Com Content Network
From 1930 to 1935, they developed dichlorodifluoromethane (CCl 2 F 2 or R12), trichlorofluoromethane (CCl 3 F or R11), chlorodifluoromethane (CHClF 2 or R22), trichlorotrifluoroethane (CCl 2 FCClF 2 or R113), and dichlorotetrafluoroethane (CClF 2 CClF 2 or R114), through Kinetic Chemicals which was a joint venture between DuPont and General Motors.
R-422B is for use in low-, medium-, and high-temperature applications. It is not recommended for use in flooded applications. R-422C is for use in medium- and low-temperature applications. The TXV power element will need to be changed to a 404A/507A element and critical seals (elastomers) may need to be replaced.
Difluoromethane serves to provide the heat capacity, pentafluoroethane decreases flammability, tetrafluoroethane reduces pressure. [1] R-407C cylinders are colored burnt orange . This refrigerant is intended as a replacement for R-22 .
A temperature switch or a thermistor can control the evaporator coil surface temperature, and a pressure switch or sensing element can monitor the suction pressure (which is in relationship with the refrigerant's evaporating temperature). Both control means can act (either directly or by means of a control unit fed by their data) upon the ...
The refrigerant is compressed by the compressor to a high-pressure and high-temperature gaseous state. The high-pressure and high-temperature gas then enters the condenser. The condenser cools the high-pressure and high-temperature gas allowing it to condense to a high-pressure liquid by transferring heat to a lower temperature medium, usually ...
They are stable, nonflammable, low toxicity [1] gases or liquids which have generally been used as refrigerants and as aerosol propellants. These include chlorofluorocarbons and hydrofluorocarbons , both of which cause ozone depletion (although the latter much less so) and contribute to global warming .
At the start of the thermodynamic cycle the refrigerant enters the compressor as a low pressure and low temperature vapor. In heat pumps, this refrigerant is typically R32 refrigerant or R290 refrigerant. Then the pressure is increased and the refrigerant leaves as a higher temperature and higher pressure superheated gas.
The path or series of states through which a system passes from an initial equilibrium state to a final equilibrium state [1] and can be viewed graphically on a pressure-volume (P-V), pressure-temperature (P-T), and temperature-entropy (T-s) diagrams. [2] There are an infinite number of possible paths from an initial point to an end point in a ...