When.com Web Search

  1. Ads

    related to: solar water heater pump controller

Search results

  1. Results From The WOW.Com Content Network
  2. Solar controller - Wikipedia

    en.wikipedia.org/wiki/Solar_controller

    The controller's main function is to switch the circulating pump on or off. The pump is usually switched on when the solar panel is hotter than the water in the store's heat exchanger and off when the panel is colder. Switching the pump on transfers the heat in the panel to the store.

  3. Solar water heating - Wikipedia

    en.wikipedia.org/wiki/Solar_water_heating

    The controller starts the pump when the water in the collector is sufficiently about 8–10 °C warmer than the water in the tank, and stops it when the temperature difference reaches 3–5 °C. This ensures that stored water always gains heat when the pump operates and prevents the pump from excessive cycling on and off.

  4. Solar-powered pump - Wikipedia

    en.wikipedia.org/wiki/Solar-powered_pump

    A PV solar-powered pump system has three main parts - one or more solar panels, a controller, and a pump.The solar panels make up most (up to 80%) of the system's cost. [citation needed] The size of the PV system is directly dependent on the size of the pump, the amount of water that is required, and the solar irradiance available.

  5. Water heating - Wikipedia

    en.wikipedia.org/wiki/Water_heating

    In the renewable energy industry (solar and heat pumps, in particular) the conflict between daily thermal Legionella control and high temperatures, which may drop system performance, is subject to heated debate. In a paper seeking a green exemption from normal Legionellosis safety standards, Europe's top CEN solar thermal technical committee TC ...

  6. Solar-assisted heat pump - Wikipedia

    en.wikipedia.org/wiki/Solar-assisted_heat_pump

    The operating conditions' optimization of this system is the main challenge, because there are two opposing trends of the performance of the two sub-systems: by way of example, decreasing the evaporation temperature of the working fluid increases the thermal efficiency of the solar panel but decreases the performance of the heat pump, and consequently the COP. [4]

  7. Solar thermal collector - Wikipedia

    en.wikipedia.org/wiki/Solar_thermal_collector

    Hot water solar systems require heat exchangers due to contamination possibilities and in the case of unglazed collectors, the pressure difference between the solar working fluid (water) and the load (pressurized cold city water). Large-scale unglazed solar hot water heaters, like the one at the Minoru Aquatic Center in Richmond, BC operate at ...