Ad
related to: testing capacitors with analog multimeter instructions diagram printable
Search results
Results From The WOW.Com Content Network
A capacitance meter is a piece of electronic test equipment used to measure capacitance, [1] mainly of discrete capacitors. Depending on the sophistication of the meter, it may display the capacitance only, or it may also measure a number of other parameters such as leakage , equivalent series resistance (ESR), and inductance .
Measuring ESR can be done by applying an alternating voltage at a frequency at which the capacitor's reactance is negligible, in a voltage divider configuration. It is easy to check ESR well enough for troubleshooting by using an improvised ESR meter comprising a simple square-wave generator and oscilloscope, or a sinewave generator of a few tens of kilohertz and an AC voltmeter, using a known ...
Inexpensive analog meters may have only a single resistance scale, seriously restricting the range of precise measurements. Typically, an analog meter will have a panel adjustment to set the zero-ohms calibration of the meter, to compensate for the varying voltage of the meter battery, and the resistance of the meter's test leads.
Cos Phi Meter: Measures the power factor Distortionmeter: Measures the distortion added to a circuit Electricity meter: Measures the amount of energy dissipated ESR meter: Measures the equivalent series resistance of capacitors Frequency counter: Measures the frequency of the current Leakage tester: Measures leakage across the plates of a ...
An LCR meter is a type of electronic test equipment used to measure the inductance (L), capacitance (C), and resistance (R) of an electronic component. [1] In the simpler versions of this instrument the impedance was measured internally and converted for display to the corresponding capacitance or inductance value.
A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.
Redistribution: The current test capacitor is switched to V ref. The test capacitor forms a charge divider with the remainder of the array whose ratio depends on the capacitor's relative size. In the first iteration, the ratio is 1:1, so the comparator's negative input becomes −V in + V ref ⁄ 2.
In electrical engineering, characteristics like current or voltage can be measured by an ammeter, a voltmeter, a multimeter, etc. The ammeter is used in series with the load, so the same current flows through the load and the ammeter.