When.com Web Search

  1. Ad

    related to: chevy map sensor test plug

Search results

  1. Results From The WOW.Com Content Network
  2. MAP sensor - Wikipedia

    en.wikipedia.org/wiki/MAP_sensor

    The MAP sensor is then used for rationality checks and to test the EGR valve. The way they do this is during a deceleration of the vehicle when there is low absolute pressure in the intake manifold (i.e., a high vacuum present in the intake manifold relative to the outside air) the powertrain control module (PCM) will open the EGR valve and ...

  3. SAE J1772 - Wikipedia

    en.wikipedia.org/wiki/SAE_J1772

    SAE J1772, also known as a J plug or Type 1 connector after its international standard, IEC 62196 Type 1, is a North American standard for electrical connectors for electric vehicles maintained by SAE International under the formal title "SAE Surface Vehicle Recommended Practice J1772, SAE Electric Vehicle Conductive Charge Coupler".

  4. Engine control unit - Wikipedia

    en.wikipedia.org/wiki/Engine_control_unit

    In 1981, a Delco Electronics ECU was used by several Chevrolet and Buick engines to control their fuel system (a closed-loop carburetor) and ignition system. [10] By 1988, Delco Electronics was the leading producer of engine management systems, producing over 28,000 ECUs per day.

  5. ALDL - Wikipedia

    en.wikipedia.org/wiki/ALDL

    Some 160 baud models constantly transmitted sensor data on startup, while others started transmitting data when placed in diagnostic mode with a resistor connected to the ALDL port. Later versions were bidirectional and operated at a much faster (but incredibly slow compared to today's standards) rate of 8192 baud.

  6. Idle air control actuator - Wikipedia

    en.wikipedia.org/wiki/Idle_air_control_actuator

    The IAC actuator is an electrically controlled device, which gets its input from the vehicle's engine control unit (ECU). The actuator is fitted such that it either bypasses the throttle or operates the throttle butterfly valve directly.

  7. Crankshaft position sensor - Wikipedia

    en.wikipedia.org/wiki/Crankshaft_position_sensor

    The functional objective for the crankshaft position sensor is to determine the position and/or rotational speed of the crank. Engine Control Units use the information transmitted by the sensor to control parameters such as ignition timing and fuel injection timing. In a diesel, the sensor will control the fuel injection.

  8. Denise Richards Breaks Down in Tears as She Recalls How She ...

    www.aol.com/denise-richards-breaks-down-tears...

    Warning: this story contains spoilers from the two-hour season 3 premiere of Special Forces: World’s Toughest Test. Denise Richards is opening up about the lasting impact of a sexual assault.

  9. IEC 62196 - Wikipedia

    en.wikipedia.org/wiki/IEC_62196

    From left: IEC Type 1/SAE J1772 inlet; Tesla NACS outlet; IEC Type 2 connector outlet IEC 62196 Plugs, socket-outlets, vehicle connectors and vehicle inlets – Conductive charging of electric vehicles is a series of international standards that define requirements and tests for plugs, socket-outlets, vehicle connectors and vehicle inlets for conductive charging of electric vehicles and is ...