Search results
Results From The WOW.Com Content Network
It is made up of a 10.5-million-U.S.-gallon (40-million-liter) storage reservoir made out of 6-inch-thick (150 mm) reinforced-concrete slabs. Two 750-US-gallon-per-minute (2,800 L/min) centrifugal pumps deliver fresh water from the city's domestic water system.
The SI unit is cubic metres per second (m 3 /s). Another unit used is standard cubic centimetres per minute (SCCM). In US customary units and imperial units, volumetric flow rate is often expressed as cubic feet per second (ft 3 /s) or gallons per minute (either US or imperial definitions).
The relationship between gallons per minute (gpm) and fixture unit is not constant, but varies with the number of fixture units. For example, 1000 FU is equivalent to 220 US gallons per minute (0.014 m 3 /s) while 2000 FU represents only 330 US gallons per minute (0.021 m 3 /s), about 1.5 times the flow rate.
The standard liter per minute (SLM or SLPM) is a unit of (molar or) mass flow rate of a gas at standard conditions for temperature and pressure (STP), which is most commonly practiced in the United States, whereas European practice revolves around the normal litre per minute (NLPM). [1]
The United Arab Emirates ceased selling petrol by the imperial gallon in 2010 and switched to the litre, with Guyana following suit in 2013. [26] [27] [28] In 2014, Myanmar switched from the imperial gallon to the litre. [29] Antigua and Barbuda has proposed switching to selling petrol by litres since 2015. [30] [19]
cubic inch per minute in 3 /min ≡ 1 in 3 /min = 2.731 177 3 × 10 −7 m 3 /s cubic inch per second in 3 /s ≡ 1 in 3 /s = 1.638 7064 × 10 −5 m 3 /s: cubic metre per second (SI unit) m 3 /s ≡ 1 m 3 /s = 1 m 3 /s gallon (US fluid) per day GPD [citation needed] ≡ 1 gal/d = 4.381 263 63 8 × 10 −8 m 3 /s gallon (US fluid) per hour GPH ...
Many folks opt to aim for the nice, square number of 1 gallon of water a day (for reference, 2.7 liters equal about 0.7 gallons), so we looked into the health benefits of drinking that much H20 ...
where: [2] Q f = total residual flow during the test (gallons per minute); c = discharge coefficient (unitless). This is usually 1.0 if using a diffuser. If using a wand to measure the stagnation pressure, the coefficient value depends on the shape of the flow hydrant orifice.