Ads
related to: 3m 2 inch grinding disc
Search results
Results From The WOW.Com Content Network
The first disc mill was invented by Kingsland in 1856. The mill consisted of a rotating disc positioned between two stationary discs. [1] [2] The grinding was adjusted by axial movement of the fixed discs. The mass with a concentration of 3-4% entered under pressure through an opening located in the center of one of the fixed discs, flowed ...
Introducing 3M™ Cubitron™ II Bonded Abrasive Grinding and Cut-Off Wheels New technology revolutionizes the grinding process ST. PAUL, Minn.--(BUSINESS WIRE)-- 3M Abrasive Systems introduces3M ...
Some discs used for cutting ceramic tile or stone are made from a solid disc with an edge coated with diamond grit. The most common size for these cutting wheels is 4 + 1 ⁄ 2 inches in diameter; however they can range from 2 to 16 inches in diameter with a thickness range from .045 in. to .125 in. Type 1 discs are flat, and type 27 discs have ...
The lap or lapping plate in this machine is 30 cm (12 in) in diameter, about the smallest size available commercially. At the other end of the size spectrum, machines with 2.4-to-3.0-metre-diameter (8 to 10 ft) plates are not uncommon, and systems with tables 9 m (30 ft) in diameter have been constructed.
Disc size is usually measured in inches or millimeters. Common disc sizes for angle grinders in the United States include 4, 4.5, 5, 6, 7, 9 and 12 inches, with the most popular sizes being the 4.5 and 5" size. In Europe, the most common sizes for angle grinder discs are 115 and 125 millimeters. Discs for pneumatic grinders are much smaller.
Surface grinding uses a rotating abrasive wheel to remove material, creating a flat surface. The tolerances that are normally achieved with surface grinding are ±2 × 10 −4 inches (5.1 μm) for grinding a flat material and ±3 × 10 −4 inches (7.6 μm) for a parallel surface. [4]