Ads
related to: installing dimmer on light switch diagram
Search results
Results From The WOW.Com Content Network
In building wiring, multiway switching is the interconnection of two or more electrical switches to control an electrical load from more than one location.A common application is in lighting, where it allows the control of lamps from multiple locations, for example in a hallway, stairwell, or large room.
A common dual dimmer module used in stage lighting A dimmer. A dimmer is a device connected to a light fixture and used to lower the brightness of the light.By changing the voltage waveform applied to the lamp, it is possible to lower the intensity of the light output.
The power control in a C-Bus system lies in a “Dimmer” or “Relay” which is installed in the DB and replaces the traditional switch used in conventional wiring. This Dimmer (or Relay) has a 120/230 V Line interconnection directly to the ceiling light and a neutral connection back from the ceiling light to the Dimmer.
The toggle light switch was invented in 1916 by William J. Newton. [2] As a component of an electrical wiring or home wiring system, the installation of light switches is regulated by some authority concerned with safety and standards. In different countries the standard dimensions of the wall mounting hardware (boxes, plates, etc.) may differ.
In addition to the light plot there are a number of other important pieces of paperwork (i.e. dimmer hookup, instrument schedule, and magic sheet) in a complete lighting design. As each part of the lighting design is relevant only to a specific group of technicians, the entire design is generally provided only to the director and master ...
As a practical matter, many 0-10 V dimming control inputs can be operated by replacing the variable control resistor with an electronic switch. When the switch is on, the control voltage is near 0 and the light is fully dim. When the switch is off, the control voltage is maximum and the light is fully bright.
Architectural style wiring diagram, with lamps and switches shown symbolically in their physical locations on the plan view of the building. Architectural wiring diagrams show the approximate locations and interconnections of receptacles, lighting, and permanent electrical services in a building. Interconnecting wire routes may be shown ...
These faders can be programmed to control a single channel (a channel is a lighting designer's numerical name for a dimmer or group of dimmers) or a group of channels (known as a ""submaster""). The console may also have provision to operate in analog to a manual desk for programming scenes or live control.