When.com Web Search

  1. Ads

    related to: guitar amp repair input jack

Search results

  1. Results From The WOW.Com Content Network
  2. RCA connector - Wikipedia

    en.wikipedia.org/wiki/RCA_connector

    The connector’s male plug and female jack are called RCA plug and RCA jack. It is also called RCA phono connector [ 5 ] or phono connector . [ 6 ] [ 7 ] The word phono in phono connector is an abbreviation of the word phonograph , because this connector was originally created to allow the connection of a phonograph turntable to a radio receiver.

  3. Guitar amplifier - Wikipedia

    en.wikipedia.org/wiki/Guitar_amplifier

    The 1/4" input jack is typically mounted on the front of the amplifier. In the simplest, least expensive amplifiers, this 1/4" jack is the only jack on the amplifier. The patch bay at the rear panel of this Line 6 Flextone guitar amp provides several additional inputs and outputs, including stereo XLR DI unit outputs.

  4. Guitar wiring - Wikipedia

    en.wikipedia.org/wiki/Guitar_wiring

    A diagram showing the wiring of a Gibson Les Paul electric guitar. Shown are the humbucker pickups with individual tone and volume controls (T and V, respectively), 3-way pickup selector switch, tone capacitors that form a passive low-pass filter, the output jack and connections between those components.

  5. Guitar tech - Wikipedia

    en.wikipedia.org/wiki/Guitar_tech

    A guitar tech is often a "jack of all trades," expected to make simple repairs: resolder a loose wiring connection inside a guitar, replace an amplifier tube, swap out a damaged speaker for a new one, reglue a loose part on an acoustic guitar, or adjust a truss rod. In cases where there is either not enough time to make the repair, or if the ...

  6. Dumble Amplifiers - Wikipedia

    en.wikipedia.org/wiki/Dumble_Amplifiers

    A few Dumble amps have a Dumbleator circuit built in, but most have "un-buffered" input jacks that tap directly out of the pre-amp and into the power amp. Dumble likely created this external loop because of the difficulty of fitting effects loop buffering into the amplifier chassis (and the limited use of effects loops for most players).

  7. Line level - Wikipedia

    en.wikipedia.org/wiki/Line_level

    Line out provides an audio signal output and line in receives a signal input. The line in/out connections on consumer-oriented audio equipment are typically unbalanced , with a 3.5 mm (0.14 inch, but commonly called "eighth inch") 3-conductor TRS minijack connector providing ground, left channel, and right channel, or stereo RCA jacks .