Search results
Results From The WOW.Com Content Network
RS-422 is a common transport mechanism for RS-232 extenders. These consist of RS-232 ports on either end of an RS-422 connection. Before hard-disk-based playout and editing systems were used, broadcast automation systems and post-production linear editing facilities used RS-422A [ check spelling ] to remotely control the players/recorders ...
Synchronous Serial Interface (SSI) is a widely used serial interface standard for industrial applications between a master (e.g. controller) and a slave (e.g. sensor). SSI is based on RS-422 [1] standards and has a high protocol efficiency in addition to its implementation over various hardware platforms, making it very popular among sensor manufacturers.
File:RS-422-423 530 pinout -- rs449's trimmedto25pin232like version '530', both for 422.png. Add languages. Page contents not supported in other languages.
The serial DCD pin can be used to accurately detect a PPS signal, as described in RFC 2783: [1] One convenient means to provide a PPS signal to a computer system is to connect that signal to a modem-control pin on a serial-line interface to the computer. The Data Carrier Detect (DCD) pin is frequently used for this purpose.
Revision A [2] changed these interchange circuits to Category II (para 4.3.6 and 4.3.7 of the standard [3]) and added a "Ring Indicator" on pin 22. Pin 23 is grounded in TIA-530-A. Confusion between the revisions has led to many incorrect wiring diagrams of this interface and most manufacturers still adhere to the original TIA-530 standard.
SPI timing diagram for both clock polarities and phases. Data bits output on blue lines if CPHA=0, or on red lines if CPHA=1, and sample on opposite-colored lines. Numbers identify data bits. Z indicates high impedance. The SPI timing diagram shown is further described below: CPOL represents the polarity of the clock.
This 9-pin RS-422 pinout has become a de facto standard, used by most brands in the broadcast industry. In the new millennium, RS-422 is slowly phased out in favor of Ethernet for control functions. However its simple way to perform troubleshooting means it will stay around for a long time.
Most commonly the USB data signals are converted to either RS-232, RS-485, RS-422, or TTL-level UART serial data. The older serial RS-423 protocol is rarely used any more, so USB to RS-423 adapters are less common.