Ads
related to: high side injection mixer pump- Chemical Metering Pumps
Full product portfolio.
Wide range-capacities & pressures
- Megaroyal Process Pump
Critical industrial processing.
Leak-proof performance.
- Process Pumps
Engineered for high volumes.
Designed for a long product life.
- Full portfolio of mixers
Over 100 years of mixing experience
Compact. Powerful. Consistent.
- Proteus Metering Pumps
Capacity to 53 GPH (201 LPH).
Remote connectivity.
- Aftermarket Services
Asset management programs
Oil & Gas and Water Treatment
- Chemical Metering Pumps
Search results
Results From The WOW.Com Content Network
If the local oscillator frequency is less than the desired reception frequency, it is called low-side injection (f IF = f RF − f LO); if the local oscillator is higher, then it is called high-side injection (f IF = f LO − f RF). The mixer will process not only the desired input signal at f RF, but also all signals present at its inputs ...
An infusion pump infuses fluids, medication or nutrients into a patient's circulatory system. It is generally used intravenously, although subcutaneous, arterial and epidural infusions are occasionally used. Infusion pumps can administer fluids in ways that would be impractically expensive or unreliable if performed manually by nursing staff.
There are two choices for : 43000 Hz and 47000 Hz, called low-side and high-side injection. With high-side injection, the spectral components that were distributed around 45000 Hz will be distributed around 2000 Hz in the reverse order, also known as an inverted spectrum.
In an ultra-high-shear inline mixer, the high-shear mixing takes place in a single or multiple passes through a rotor–stator array. The mixer is designed to subject the product to higher shear and a larger number of shearing events than a standard inline rotor–stator mixer, producing an exceptionally narrow particle-size distribution.
The oil is contained in a reservoir that connects to a small oil pump in the engine, which needs to be periodically refilled. Oil injection pump on a Yamaha DX100- just behind the carburettor (visible on the left) It is the primary component of two-stroke automatic lubrication system. Amount of two-stroke oil injected by the pump depends on the ...
For high quality rotating drive systems, plunger motors are generally used. Whereas the speed of hydraulic pumps range from 1200 to 1800 rpm, the machinery to be driven by the motor often requires a much lower speed. This means that when an axial plunger motor (swept volume maximum 2 litres) is used, a gearbox is usually needed.
Ad
related to: high side injection mixer pump