Ad
related to: harga kabel utp 1 meter 2
Search results
Results From The WOW.Com Content Network
Shielded Cat 5e, Cat 6/6A, and Cat 8/8.1 cables typically have F/UTP construction, while shielded Cat 7/7 A and Cat 8.2 cables use S/FTP construction. [ 9 ] Because the shielding is conductive, it may also serve as a path to ground.
1 2 1 1 PE 1 1 250 voice grade ~12 LAN: StarLAN-10 802.3e-1988: obsolete 10 2 1 1 PE 10 10 ~100 voice grade ~12 LAN LattisNet: pre 802.3i-1990: obsolete 10 2 1 1 PE 10 10 100 voice grade ~12 LAN 10BASE-T: 802.3i-1990 (CL14) legacy 10 2 1 1 PE: 10 10 100 Cat 3: 16 LAN [34] 10BASE-T1S: 802.3cg-2019: current 10 1 1 0.8 4B5B DME: 25 12.5 15 or 25 ...
By reducing the original signal rate to 1 ⁄ 4 or 1 ⁄ 2, the link speed drops to 2.5 or 5 Gbit/s, respectively. [5] The spectral bandwidth of the signal is reduced accordingly, lowering the requirements on the cabling, so that 2.5GBASE-T and 5GBASE-T can be deployed at a cable length of up to 100 m on Cat 5e or better cables. [6] [7]
10BASE2 (also known as cheapernet, [1] thin Ethernet, thinnet, and thinwire) is a variant of Ethernet that uses thin coaxial cable terminated with BNC connectors to build a local area network. During the mid to late 1980s, this was the dominant 10 Mbit/s Ethernet standard.
Because the only difference between the T568A and T568B pin and pair assignments are that pairs 2 and 3 are swapped, a crossover cable may be envisioned as a cable with one modular connector following T568A and the other T568B (see TIA/EIA-568 wiring). Such a cable will work for 10BASE-T or 100BASE-TX.
Class II: Up to 2 GHz (2000 MHz) using Category 8.2 cable and connectors (ISO/IEC 11801-1, Edition 1.0 2017-11) The standard link impedance is 100 Ω. (The older 1995 version of the standard also permitted 120 Ω and 150 Ω in Classes A−C, but this was removed from the 2002 edition.)
Generally, layers are named by their specifications: [8] 10, 100, 1000, 10G, ... – the nominal, usable speed at the top of the physical layer (no suffix = megabit/s, G = gigabit/s), excluding line codes but including other physical layer overhead (preamble, SFD, IPG); some WAN PHYs (W) run at slightly reduced bitrates for compatibility reasons; encoded PHY sublayers usually run at higher ...
Category 2 cable, also known as Cat 2, is a grade of unshielded twisted pair cabling designed for telephone and data communications. The maximum frequency suitable for transmission over Cat 2 cable is 4 MHz, and the maximum bandwidth is 4 Mbit/s. [1] [2] Cat 2 cable contains 4 pairs of wires, or 8 wires total. [3]