Search results
Results From The WOW.Com Content Network
A pneumatic buffer with sections cut away. A buffer is a part of the buffers and chain coupler system used on the railway systems of many countries, among them most of those in Europe, for attaching railway vehicles together (in North America, rolling stock instead has draft gear built into the couplers).
The balance lever coupling, also central buffer coupling with two screw coupling, is a coupler commonly used on narrow gauge railroads with tight curves. By swapping the pulling and pushing devices, the standard screw coupling used on standard gauge railroads became a center buffer coupling with one screw coupling on each side of the buffer.
Narrow gauge flat wagons, 750 mm (2 ft 5 + 1 ⁄ 2 in).Note the single buffer with a hook on the right side and a chain on the other. On some narrow-gauge lines in Europe, and on the Paris Metro, a simplified version of the loose-coupler is used, consisting of a single central buffer with a chain underneath.
Rusted chair screw Chair screw (French: Tire-fonds) A chair screw (also known as coach screw [16]) is a large (~6 in or 152 mm length, slightly under 1 in or 25 mm diameter) metal screw used to fix a chair (for bullhead rail), baseplate (for flat bottom rail) or to directly fasten a rail. Chair screws are screwed into a hole bored in the ...
The diagram from Beard's 1897 coupler patent [1]. Janney couplers were first patented in 1873 by Eli H. Janney (U.S. patent 138,405). [2] [3] Andrew Jackson Beard was amongst various inventors that made a multitude of improvements to the knuckle coupler; [1] Beard's patents were U.S. patent 594,059 granted 23 November 1897, which then sold for approximately $50,000, and U.S. patent 624,901 ...
A commonly used measurement relating to a rail vehicle is its length over headstocks, which is the length of the vehicle excluding its couplings or buffers (if any). [2] Alternative expressions for length over headstocks are length over coupler pulling faces , usually applied to Janney couplers , and length over buffers .
A buffer stop, bumper, bumping post, bumper block or stopblock (US), is a device to prevent railway vehicles from going past the end of a physical section of track. The design of the buffer stop is dependent, in part, on the kind of couplings that the railway uses, since the coupling gear is the first part of the vehicle that the buffer stop ...
The Ann Arbor Railroad of Michigan developed a system of making cars secure that was adopted by many other lines. Screw jacks were placed on the corners of the railcar and the car was raised slightly to take its weight off its wheels. Chains and turnbuckles were placed around the car frame and hooked onto the rails and tightened.