Search results
Results From The WOW.Com Content Network
ATX is the most common motherboard design. [2] Other standards for smaller boards (including microATX, FlexATX, nano-ITX, and mini-ITX) usually keep the basic rear layout but reduce the size of the board and the number of expansion slots.
PC/104 is an embedded computer standard which defines both a form factor and computer bus. PC/104 is intended for embedded computing environments. Single-board computers built to this form factor are often sold by COTS vendors, which benefits users who want a customized rugged system, without months of design and paper work.
As electronic hardware has become smaller following Moore's law and related patterns, ever-smaller form factors have become feasible. Specific technological advances, such as PCI Express, have had a significant design impact, though form factors have historically evolved slower than individual components.
The ATX specification requires that the power-good signal ("PWR_OK") go high no sooner than 100 ms after the power rails have stabilized, and remain high for 16 ms after loss of AC power, and fall (to less than 0.4 V) at least 1 ms before the power rails fall out of specification (to 95% of their nominal value).
In computer design, microATX (sometimes referred to as μATX, uATX [1] or mATX) [2] is a standard motherboard form factor introduced in December 1997. [3] The maximum size of a microATX motherboard is 9.6 × 9.6 in (244 × 244 mm).
Baby AT motherboard An ATX Form Card, used by later Baby-AT motherboards to allow for USB, PS/2 mouse, and IR connectivity through headers. In 1987, the Baby AT form factor was introduced, based on the motherboard found in the IBM PC/XT 286 (5162) [2] and soon after all computer makers abandoned AT for the cheaper and smaller Baby AT form factor, using it for computers that spanned several ...
The DTX form factor is a variation of ATX specification [1] designed especially for small form factor PCs (especially for HTPCs) with dimensions of 8 × 9.6 inches (203 × 244 mm). [2] An industry standard intended to enable interchangeability for systems similar to Shuttle 's original "SFF" designs, [ 3 ] AMD announced its development on ...
FlexATX is a motherboard form factor derived from ATX.The specification was released in 1999 by Intel as an addendum to the microATX specification. It uses a subset of the motherboard mounting holes required for microATX and the same I/O plate system as ATX and microATX.