Search results
Results From The WOW.Com Content Network
A mobile phone signal (also known as reception and service) is the signal strength (measured in dBm) received by a mobile phone from a cellular network (on the downlink). Depending on various factors, such as proximity to a tower , any obstructions such as buildings or trees, etc. this signal strength will vary.
Cellular network standards and generation timeline. This is a comparison of standards of wireless networking technologies for devices such as mobile phones.A new generation of cellular standards has appeared approximately every tenth year since 1G systems were introduced in 1979 and the early to mid-1980s.
Mobile Information Device Profile (MIDP) is a specification published for the use of Java on embedded devices such as mobile phones and PDAs.MIDP is part of the Java Platform, Micro Edition (Java ME) framework and sits on top of Connected Limited Device Configuration (CLDC), a set of lower level programming interfaces.
For very low-power systems, such as mobile phones, signal strength is usually expressed in dB-microvolts per metre (dBμV/m) or in decibels above a reference level of one milliwatt . In broadcasting terminology, 1 mV/m is 1000 μV/m or 60 dBμ (often written dBu). Examples. 100 dBμ or 100 mV/m: blanketing interference may occur on some receivers
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
where N c is the number of channels per cell, BW is the system bandwidth, and A c is Area of cell. Sectorization is briefly described in traffic load and cell size as a way to cut down equipment costs in a cellular network. [2] When applied to clusters of cells sectorization also reduces co-channel interference, according to Walke. [1]
A separate test to check my cell phone signal strength found that at home, I had something called RSRP of -108 – generally considered “poor signal,” and at the office, I had RSRP of -111 ...
For many components, only proprietary drivers are available [1] (open source phones usually seek components with open drivers. [citation needed]) If firmware is not updatable and does not have control over any other part of the phone, it might be considered equivalent to part of the hardware. However, these conditions do not hold for cellular ...