Search results
Results From The WOW.Com Content Network
Automixers balance multiple sound sources based on each source's level, quickly and dramatically adjusting the various signal levels automatically. [2] Automixers are used in live sound reinforcement to maintain a steady limit on the overall signal level of the microphones; if a public address system is set up so that one microphone will not feed back, then, in general, the automixer will ...
To maximize gain before feedback, the amount of sound energy that is fed back to the microphones must be reduced as much as is practical.As sound pressure falls off with 1/r with respect to the distance r in free space, or up to a distance known as reverberation distance in closed spaces (and the energy density with 1/r²), it is important to keep the microphones at a large enough distance ...
This means that (1) moving the microphone closer to the sound source increases the signal level produced by the microphone, and (2) moving the microphone further away from undesirable noise sources will diminish the amount of noise in the microphone signal. Microphone placement is therefore an important aspect of gain staging [citation needed].
The internal electronic circuitry of an active noise-canceling mic attempts to subtract noise signal from the primary microphone. The circuit may employ passive or active noise canceling techniques to filter out the noise, producing an output signal that has a lower noise floor and a higher signal-to-noise ratio .
The distance from the sound source to the microphone is a critical element of GBF. Greater GBF is obtained with the performer closer to the microphone; an instance of the inverse-square law. If the performer reduces the distance to the microphone by half, the PAG is increased by 6 dB while the environmental sounds remain relatively the same. [3 ...
MP3Gain is an audio normalization software tool. The tool is available on multiple platforms and is free software.It analyzes the MP3 and reversibly changes its volume. The volume can be adjusted for single files or as album where all files would have the same perceived loudness.
The position of the pop filter is different in different recording situations, with a further position from the microphone causing fewer pop sounds. More distance means increasing the microphone gain and gaining more room noise. Normally, to get good quality, the pop filter should be placed about 2–6 inches (5–15 cm) away from the ...
Spill occurs when sound is detected by a microphone not intended to pick it up (for example, the vocals being detected by the microphone for the guitar). [3] Spill is often undesirable in popular music recording, [4] as the combined signals during the mix process can cause phase cancellation and may cause difficulty in processing individual tracks. [2]