Ad
related to: tunneling vs port forwarding on router
Search results
Results From The WOW.Com Content Network
Port forwarding via NAT router. In computer networking, port forwarding or port mapping is an application of network address translation (NAT) that redirects a communication request from one address and port number combination to another while the packets are traversing a network gateway, such as a router or firewall.
Tunneling a TCP-encapsulating payload (such as PPP) over a TCP-based connection (such as SSH's port forwarding) is known as "TCP-over-TCP", and doing so can induce a dramatic loss in transmission performance — known as the TCP meltdown problem [6] [7] which is why virtual private network (VPN) software may instead use a protocol simpler than ...
A PPTP tunnel is instantiated by communication to the peer on TCP port 1723. This TCP connection is then used to initiate and manage a GRE tunnel to the same peer. The PPTP GRE packet format is non standard, including a new acknowledgement number field replacing the typical routing field in the GRE header. However, as in a normal GRE connection ...
In computer networking, Layer 2 Tunneling Protocol (L2TP) is a tunneling protocol used to support virtual private networks (VPNs) or as part of the delivery of services by ISPs. It uses encryption ('hiding') only for its own control messages (using an optional pre-shared secret), and does not provide any encryption or confidentiality of content ...
NAT Port Mapping Protocol (NAT-PMP) is a protocol introduced by Apple as an alternative to IGDP. Port Control Protocol (PCP) is a successor of NAT-PMP. UPnP Internet Gateway Device Protocol (UPnP IGD) is supported by many small NAT gateways in home or small office settings. It allows a device on a network to ask the router to open a port.
The Point-to-Point Protocol over Ethernet (PPPoE) is a network protocol for encapsulating Point-to-Point Protocol (PPP) frames inside Ethernet frames. It appeared in 1999, in the context of the boom of DSL as the solution for tunneling packets over the DSL connection to the ISP's IP network, and from there to the rest of the Internet.
The server then relays each client's information to the other, and using that information each client tries to establish direct connection; as a result of the connections using valid port numbers, restrictive firewalls or routers accept and forward the incoming packets on each side.
There is a difference between a "relay router" and a "border router" (also known as a "6to4 border router"). A 6to4 border router is an IPv6 router supporting a 6to4 pseudo-interface. It is normally the border router between an IPv6 site and a wide-area IPv4 network, where the IPv6 site uses 2002:: / 16 co-related to the IPv4 address used later ...