Ads
related to: chrysler 300 alternatives to gas powered engines pictures
Search results
Results From The WOW.Com Content Network
The Chrysler turbine engine program that produced the Turbine Car began during the late 1930s and created prototypes that completed long-distance trips in the 1950s and early 1960s. The A-831 engines that powered the Ghia-designed Turbine Car could operate on many fuels, required less maintenance, and lasted longer than conventional piston engines.
Engine compartment of a 1963 Chrysler Turbine automobile. The Chrysler turbine engine is a series of gas turbine engines developed by Chrysler intended to be used in road vehicles. In 1954, Chrysler Corporation disclosed the development and successful road testing of a production model Plymouth sport coupe which was powered by a turbine engine. [1]
The Chrysler 300 continues a tradition of full-sized, front-engine, rear-wheel drive, V8-powered luxury sedans the company has offered, starting in the 1940s with the Chrysler Saratoga and Chrysler New Yorker, followed by the Chrysler Windsor, Chrysler Newport, and the Chrysler Cordoba, with the last rear wheel drive sedan, the Chrysler Fifth Avenue that ended production in 1989.
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...
The Polyspheric or Poly engines were V8 engines produced by Chrysler from 1955 to 1958 as lower-cost alternatives to the Hemi engines. [1] These engines were based on the Hemi engines, using the same blocks and crankshaft parts, but completely different cylinder heads, pushrods, exhaust manifolds and pistons.
It is not the same as Chrysler's 360 V8. [4] Chrysler continued production of the AMC 360 engine after the 1987 buyout of AMC to power the full-size Jeep Wagoneer (SJ) SUV that was produced until 1991. [5] It was one of the last carbureted car/truck engines built in North America. [6] Chrysler never used this engine in any other vehicle.
The GT-300 was designed with a 3.5:1 compression ratio and nominal design turboshaft speeds of 24,000 RPM (gasifier) and 12,000 RPM (power). Engine accessories are driven by the gasifier turboshaft through a perpendicular bevel gear arrangement; a conventional automotive starting motor is used to crank the accessory drive shaft (and gasifier ...
The C-300 was a racecar aimed at the NASCAR circuits that was sold for private ownership to qualify for homologation purposes, with Chrysler's most powerful engine, the OHV 331 cu in (5.4 L) FirePower "Hemi" V8, due to the hemispheric shape of the cylinder head, fitted with dual four barrel carburetors, two overhead valves per cylinder with ...