Search results
Results From The WOW.Com Content Network
The overhand knot is one of the most fundamental knots, and it forms the basis of many others, including the simple noose, overhand loop, angler's loop, reef knot, fisherman's knot, half hitch, and water knot. The overhand knot is a stopper, especially when used alone, and hence it is very secure, to the point of jamming badly. It should be ...
The reef knot can capsize if one of its standing ends is pulled.. A knot that has capsized or spilled has deformed into a different structure. Although capsizing is sometimes the result of incorrect tying or misuse, it can also be done purposefully in certain cases to strengthen the knot (see the carrick bend [4]) or to untie a seized knot which would otherwise be difficult to release (see ...
The reef knot, or square knot, is an ancient and simple binding knot used to secure a rope or line around an object. It is sometimes also referred to as a Hercules knot or Heracles knot . The knot is formed by tying a left-handed overhand knot between two ends, instead of around one end, and then a right-handed overhand knot via the same ...
This list of knots includes many alternative names for common knots and lashings. Knot names have evolved over time, and there are many conflicting or confusing naming issues. The overhand knot, for example, is also known as the thumb knot. The figure-eight knot is also known as the Savoy knot or the Flemish knot.
Water knot (also known as Tape Knot, Double Overhand Bend, Ring Bend): The Water knot is useful to tie together two ends of ropes. Often used with webbing. Binding Strangle knot: The Strangle knot is a simple binding knot. It forms both sides of a Double fisherman's knot, and is also used to back up loop knots and both ends of bends. Hitches
A slipped half hitch [1] [2] is a knot in which the weight of the load the rope carries depresses the loop sufficiently to keep it in place until the load item is placed in its location. When no longer required the free end may be pulled and draw the loop through and so release the load.
Friction knots are held in place by the friction between the windings of line. Knotted-ends knots are held in place by the two ends of the line being knotted together. Stopping may be either a temporary whipping or seizing, the commonest variety consisting of a few round turns finished off with a reef knot .
Water knot before tightening. Once tied, for additional security each end should be tied in a double overhand stopper knot around the other standing end.. Some testing has shown that the water knot, in certain conditions, can slip very slightly but very consistently, with cyclic loading and unloading at relatively low forces; it is the tail on the exterior that slips (this would be the blue ...