Ads
related to: cable modem router connection diagram
Search results
Results From The WOW.Com Content Network
In network topology, a cable modem is a network bridge that conforms to IEEE 802.1D for Ethernet networking (with some modifications). The cable modem bridges Ethernet frames between a customer LAN and the coax network. Technically, it is a modem because it must modulate data to transmit it over the cable network, and it must demodulate data ...
Cable modem termination system. A cable modem termination system (CMTS, also called a CMTS Edge Router) [1] is a piece of equipment, typically located in a cable company's headend or hubsite, which is used to provide data services, such as cable Internet or Voice over IP, to cable subscribers.
The following diagram shows a scenario where an Ethernet-connected ADSL modem acts as a PPPoE-to-PPPoA protocol converter and the service provider offers a PPPoA service and does not understand PPPoE. There is no PPPoEoA in this protocol chain. This is an optimally protocol-efficient design for a separate ADSL modem connected to a router by ...
A modem and router work in tandem to deliver you an internet connection and then grant access to your various devices. Modem vs. router: The differences between the pieces of hardware that connect ...
For example, the sample diagram does not indicate the physical type of connection between the PCs and the switch, but since a modern LAN is depicted, Ethernet may be assumed. If the same style of line was used in a WAN (wide area network) diagram, however, it may indicate a different type of connection.
The main purpose of a router is to connect multiple networks and forward packets destined either for directly attached networks or more remote networks. A router is considered a layer-3 device because its primary forwarding decision is based on the information in the layer-3 IP packet, specifically the destination IP address. When a router ...
A CSU/DSU can have an external connection point or it can be integrated into a modular card installed in a router. A CSU/DSU is the equivalent of the modem for an entire LAN. The DCE, commonly a modem or CSU/DSU, is the device used to convert the user data from the DTE into a form acceptable to the WAN service provider transmission link. [1]
Check the physical connection - A loose cable or cord can often be the cause of a connection problem. Make sure everything is securely connected to the wall and device. 3. Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure ...