Search results
Results From The WOW.Com Content Network
The saturation vapor density (SVD) is the maximum density of water vapor in air at a given temperature. [1] The concept is related to saturation vapor pressure (SVP). It can be used to calculate exact quantity of water vapor in the air from a relative humidity (RH = % local air humidity measured / local total air humidity possible ) Given an RH percentage, the density of water in the air is ...
using Plots # Saturated water vapor pressure [Pa] # See Ham, 2005. Useful Equations and Tables in Micrometeorology function water_vapor_saturated_pressure (Ta, P) Ta = Ta-273.15 es = (1.0007 + (3.46e-5 * (P / 1e3))) * 0.61121 * exp ((17.502 * Ta) / (Ta + 240.97)) * 1e3 return es end function water_vapor_density (e, Tair) Rs_v = 461.5 # J/(kg.K) specific gas constant for water vapor ρv = e ...
saturated adiabats or pseudoadiabats = lines representing the temperature of a rising parcel saturated with water vapor mixing ratio = lines representing the dewpoint of a rising parcel The lapse rate , dry adiabatic lapse rate (DALR) and moist adiabatic lapse rate (MALR), are obtained.
An important basic value, which is not registered in the table, is the saturated vapor pressure at the triple point of water. The internationally accepted value according to measurements of Guildner, Johnson and Jones (1976) amounts to: P w (t tp = 0.01 °C) = 611.657 Pa ± 0.010 Pa at (1 − α) = 99%
The saturation with respect to water cannot be measured much below –50 °C, so manufacturers should use one of the following expressions for calculating saturation vapour pressure relative to water at the lowest temperatures – Wexler (1976, 1977), [1] [2] reported by Flatau et al. (1992)., [3] Hyland and Wexler (1983) or Sonntag (1994 ...
— "Values ranging from 21.3 to 21.5 gm/cm 3 at 20 °C have been reported for the density of annealed platinum; the best value being about 21.45 gm/cm 3 at 20 °C." 21.46 g/cm 3 — Rose, T. Kirke. The Precious Metals, Comprising Gold, Silver and Platinum .
A "wet" fluid shows a negative saturation vapor curve. If overheating before the expansion is limited, a two-phase state is obtained at the end of the expansion. An "isentropic" fluid shows a vertical saturation vapor curve. It remains very close to the saturated vapor state after an hypothetical isentropic expansion.
A saturation dome uses the projection of a P–v–T diagram (pressure, specific volume, and temperature) onto the P–v plane. The points that create the left-hand side of the dome represent the saturated liquid states, while the points on the right-hand side represent the saturated vapor states (commonly referred to as the “dry” region).