Search results
Results From The WOW.Com Content Network
When first introduced, it was relatively rare for British cars to have independently sprung rear wheels, [1] most production cars of the time using live rear axles. Independent suspension systems offer the advantage of lower unsprung mass to improve roadholding, and when properly designed, the ability to maintain the roadwheels perpendicular to ...
These suspension upgrades were included in the 1964 model year, before Chevrolet completely redesigned the suspension with a fully independent setup, when the second generation was released in 1965. GM's attempts to discredit Nader further brought negative publicity, at the same time that the Ford Mustang was putting significant strain on ...
In 1963 Jaguar introduced the Jaguar S-Type as a development of the Mark 2. It used a new intermediate-width, 54-inch (1,400 mm) version of the independent rear suspension in place of the live rear axle of the Mark 2. Other differences from the Mark 2 were extended rear bodywork to provide for a larger boot, a changed roofline for more rear ...
The Jaguar XJ (X300) is a full-size luxury saloon car manufactured by Jaguar Cars between 1994 and 1997. It was the first Jaguar XJ produced entirely under Ford Motor Company ownership, and can be considered an evolution of the outgoing XJ40 generation. Like all previous XJ generations, it features the Jaguar independent rear suspension ...
The Jaguar XJ (X308) is a full-size luxury saloon car manufactured and marketed by Jaguar Cars for years 1997–2003 across two generations and featuring the Jaguar AJ-V8 engine and Jaguar independent rear suspension. [3] It was the third and final evolution of the Jaguar XJ40 platform that had been in production since 1986.
Change in camber due to cornering forces can cause loss of rear-wheel adhesion leading to oversteer—a dynamically unstable condition that can cause a vehicle to spin. This is an especially severe problem when a swing axle is used in a rear-engine design, because of the greater side-g forces on the rear wheels from the mass of the engine.
It differed from earlier large Jaguar saloons in having 14" wheels instead of the more common 15". It used a wider-track version of Jaguar's IRS unit first seen on the E Type, which was subsequently used on Jaguar vehicles until X308 production ended in 2003. The front suspension used double wishbones with coil springs and telescopic dampers.
The XJ6 replaced most of Jaguar's saloons – which, in the 1960s, had expanded to four separate ranges. It carried over the 2.8-litre (2,792 cc (170.4 cu in)) and 4.2-litre (4,235 cc (258.4 cu in)) cylinder versions of Jaguar's renowned straight-six XK engine, and front and rear suspensions, from previous models: the widest version of Jaguar's IRS unit from the Mark X, and the subframe ...