Search results
Results From The WOW.Com Content Network
Projectile path values are determined by both the sight height, or the distance of the line of sight above the bore centerline, and the range at which the sights are zeroed, which in turn determines the elevation angle. A projectile following a ballistic trajectory has both forward and vertical motion.
The temperature depends on the energy released and the heat loss to the sides of the barrel and chamber. As the projectile travels down the barrel, the volume the gas occupies behind the projectile increases. Some energy is lost in deforming the projectile and causing it to spin. There are also frictional losses between the projectile and the ...
Transitional ballistics, also known as intermediate ballistics, [1] is the study of a projectile's behavior from the time it leaves the muzzle until the pressure behind the projectile is equalized, so it lies between internal ballistics and external ballistics. [2] [3] [4] [5]
A sling is a projectile weapon typically used to throw a blunt projectile such as a stone, clay or lead "sling-bullet". A sling has a small cradle or pouch in the middle of two lengths of cord. The sling stone is placed in the pouch. The middle finger or thumb is placed through a loop on the end of one cord, and a tab at the end of the other ...
A ballistic pendulum is a device for measuring a bullet's momentum, from which it is possible to calculate the velocity and kinetic energy. Ballistic pendulums have been largely rendered obsolete by modern chronographs, which allow direct measurement of the projectile velocity.
For projectiles in unpowered flight, its velocity is highest at leaving the muzzle and drops off steadily because of air resistance.Projectiles traveling less than the speed of sound (about 340 m/s (1,100 ft/s) in dry air at sea level) are subsonic, while those traveling faster are supersonic and thus can travel a substantial distance and even hit a target before a nearby observer hears the ...
This misconception is due to the metal's fluid-like behavior, which is caused by the massive pressures produced during the detonation of the explosive causing the metal to flow plastically. When used in the anti-tank role, a projectile that uses a shaped-charge warhead is known by the acronym HEAT (high-explosive anti-tank).
The formula for calculating the ballistic coefficient for small and large arms projectiles only is as follows: = [2] where: C b,projectile, ballistic coefficient as used in point mass trajectory from the Siacci method (less than 20 degrees). [3] m, mass of bullet