Search results
Results From The WOW.Com Content Network
The traditional hot water recirculation system uses the existing cold water line as return line from the point of use located farthest from the hot water tank back to the hot water tank. The first of two system types has a pump mounted at the hot water heater while a "normally open" thermostatic control valve gets installed at the farthest ...
An aquastat is a device used in hydronic heating systems for controlling water temperature. [ 1 ] [ 2 ] To prevent the boiler from firing too frequently, aquastats have a high limit temperature and a low limit.
Water is introduced into the steam drum and is circulated around the boiler, leaving only as steam. What makes the forced circulation boiler different is its use of a secondary pump that circulates water through the boiler. The secondary pump takes the feed water going to the boiler and raises the pressure of the water going in.
A zone-valved system is dependent upon a single circulator pump. If it fails, the system becomes completely inoperable. The system can be harder to design, requiring both "SPDT" thermostats or relays and the ability of the system to withstand the fault condition whereby all zone valves are closed simultaneously. Zone valves increase the ...
Water recycling showers (also known as recycle showers, circulation showers or re-circulation showers) are showers that use a basin and a pump to re-use the water during a shower session. The technology is used to reduce the use of drinking water and primary energy consumption for water heating .
The evaporator uses separate parts to create the overall system; a heat exchanger, separation tank and for the forced circulation system (as opposed to the natural circulation system) a circulation pump are standard although can be subject to change depending on the liquids properties of the mixtures being separated and specific design.
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate
A control loop is the fundamental building block of control systems in general and industrial control systems in particular. It consists of the process sensor, the controller function, and the final control element (FCE) which controls the process necessary to automatically adjust the value of a measured process variable (PV) to equal the value of a desired set-point (SP).