Ads
related to: macpherson strut diagram printable template
Search results
Results From The WOW.Com Content Network
A simple MacPherson strut suspension on the left front wheel of a rear-wheel drive vehicle. The front of the vehicle is at bottom right of the image. Upper green: Vehicle body/strut interface Red: Steering knuckle or hub carrier Blue: Lower control arm or track control arm Light blue: Steering gear tie rod or track rod Lower purple: Radius rod
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate
MacPherson strut suspension, track control arm coloured dark blue. In automotive suspension, a control arm, also known as an A-arm, is a hinged suspension link between the chassis and the suspension upright or hub that carries the wheel. In simple terms, it governs a wheel's vertical travel, allowing it to move up or down when driving over ...
Automotive suspension design is an aspect of automotive engineering, concerned with designing the suspension for cars and trucks. Suspension design for other vehicles is similar, though the process may not be as well established. The process entails Selecting appropriate vehicle level targets; Selecting a system architecture
The two arms, the spindle, and the body, form a four-bar link.Use of the linkage at the lower suspension connection of either a MacPherson strut or a short long arms suspension readily gives an effective virtual ball joint outboard of the spindle, which is very useful for a suspension designer, allowing negative scrub radius whilst allowing the ball joints to move in and thus out of the way of ...
As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.
This became the first car to use the true MacPherson strut suspension. Ford's Poissy plant got off to a slow start with the Vedette, however, and the Fords Zephyr and Consul which captured the headlines at the 1950 London Motor Show have also been claimed as the first cars to appear "in mass production" with MacPherson struts. [2]
However, a three-speed gearbox, with synchromesh only on second and top, was retained. The Consul was also the first British production car to use the now-common MacPherson strut independent front suspension. [6] The bench front seat was trimmed in PVC, and the handbrake was operated by an umbrella-style pull lever under the facia (dash).