Search results
Results From The WOW.Com Content Network
The EBW was invented by Luis Alvarez and Lawrence Johnston for the Fat Man–type bombs of the Manhattan Project, during their work in Los Alamos National Laboratory.The Fat Man Model 1773 EBW detonators used an unusual, high reliability detonator system with two EBW "horns" attached to a single booster charge, which then fired each of the 32 explosive lens units.
Ordinary detonators usually take the form of ignition-based explosives. While they are mainly used in commercial operations, ordinary detonators are still used in military operations. This form of detonator is most commonly initiated using a safety fuse, and used in non time-critical detonations e.g. conventional munitions disposal.
A shock tube detonator is a non-electric explosive fuze or initiator in the form of small-diameter hollow plastic tubing used to transport an initiating signal to an explosive by means of a shock wave (also known as a percussive wave) traveling the length of the tube. [1] Shock tube is used to convey a detonation signal to a detonator. Shock ...
Counter-IED equipment are created primarily for military and law enforcement. They are used for standoff detection of explosives and explosive precursor components and defeating the Improvised Explosive Devices (IEDs) devices themselves as part of a broader counter-terrorism, counter-insurgency, or law enforcement effort.
(A) Slapper detonator's pellet or flyer impacts a wider area of surface on the explosive output charge, and even though energy is lost to the sides of the area impacted, a cone of explosive is efficiently compressed. (B) EBW detonators only initiate a single point, and energy is lost in all directions, making the energy transfer less efficient.
Detonation cord will initiate most commercial high explosives (dynamite, gelignite, sensitised gels, etc.) but will not initiate less sensitive blasting agents like ANFO on its own. 25 to 50 grain/foot (5.3 to 10.6 g/m) detonation cord has approximately the same initiating power as a #8 blasting cap in every 2 to 4 inches (5 to 10 cm) along its ...
Internally the mine contains a layer of C-4 explosive behind a matrix of about seven hundred 1 ⁄ 8-inch-diameter (3.2 mm) steel balls set into an epoxy resin. When the M18A1 is detonated, the explosion drives the matrix forward, out of the mine at a velocity of 1,200 m/s (3,937 ft/s), [ 1 ] at the same time breaking it into individual fragments.
The ZND detonation model is a one-dimensional model for the process of detonation of an explosive. It was proposed during World War II independently by Yakov Zeldovich, [1] John von Neumann, [2] and Werner Döring, [3] hence the name. This model admits finite-rate chemical reactions and thus the process of detonation consists of the following ...