Ad
related to: convert feet decimal to inches fraction
Search results
Results From The WOW.Com Content Network
For conversion of metric units to feet/inches, the frac parameter can be specified to either show the output inches as decimals (frac=10) or as a vulgar fraction (frac=desired denominator; the default is 2 for halves). The frac parameter is ignored for conversion of feet/inches to metres.
The hands value has at most one digit after the decimal mark, and has an optional fraction. A precision of 2 assumes |frac=2 (round to nearest 1 ⁄ 2 inch). A precision of 3 or more assumes |frac=4 (round to nearest 1 ⁄ 4 inch). If ever needed, |frac=8 can be used to round to the nearest 1 ⁄ 8 inch. {{convert|27.63|in|hand}} → 27.63 ...
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.
By {{Convert}} default, the conversion result will be rounded either to precision comparable to that of the input value (the number of digits after the decimal point—or the negative of the number of non-significant zeroes before the point—is increased by one if the conversion is a multiplication by a number between 0.02 and 0.2, remains the ...
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...
There are anecdotal objections to the use of metric units in carpentry and the building trades, on the basis that it is easier to remember an integer number of inches plus a fraction, rather than a measurement in millimeters, [9] or that foot-inch measurements are more suitable when distances are frequently divided into halves, thirds, and ...
For repeating patterns that begin immediately after the decimal point, the result of the conversion is the fraction with the pattern as a numerator, and the same number of nines as a denominator. For example: 0. 5 = 5/9 0. 62 = 62/99 0. 264 = 264/999 0. 6291 = 6291/9999