Search results
Results From The WOW.Com Content Network
The two factors combine to produce a total of four data transfers per internal clock cycle. Since the DDR2 internal clock runs at half the DDR external clock rate, DDR2 memory operating at the same external data bus clock rate as DDR results in DDR2 being able to provide the same bandwidth but with better latency. Alternatively, DDR2 memory ...
Similarly, in DDR2 with a 4n pre-fetch buffer, four consecutive data words are read and placed in buffer while a clock, which is twice faster than the internal clock of DDR, transmits each of the word in consecutive rising and falling edge of the faster external clock [8]
DDR2 started to be effective by the end of 2004, as modules with lower latencies became available. [19] Memory manufacturers stated that it was impractical to mass produce DDR1 memory with effective transfer rates in excess of 400 MHz (i.e. 400 MT/s and 200 MHz external clock) due to internal speed limitations.
Without knowing the clock frequency it is impossible to state if one set of timings is "faster" than another. For example, DDR3-2000 memory has a 1000 MHz clock frequency, which yields a 1 ns clock cycle. With this 1 ns clock, a CAS latency of 7 gives an absolute CAS latency of 7 ns. Faster DDR3-2666 memory (with a 1333 MHz clock, or 0.75 ns ...
The naming convention for DDR, DDR2 and DDR3 modules specifies either a maximum speed (e.g., DDR2-800) or a maximum bandwidth (e.g., PC2-6400). The speed rating (800) is not the maximum clock speed, but twice that (because of the doubled data rate). The specified bandwidth (6400) is the maximum megabytes transferred per second using a 64-bit width.
DDR and DDR2 memory is usually installed in single- or dual-channel configuration. DDR3 memory is installed in single-, dual-, tri-, and quad-channel configurations. Bit rates of multi-channel configurations are the product of the module bit-rate (given below) and the number of channels.
Credit - Illustration by TIME; Getty Images. O n a recent trip to Tucson, I heard zero complaints about a pending hour of lost sleep. On March 10, 2024—when most clocks across the country will ...
Double data rate (DDR) RAM performs two transfers per clock cycle, and it is usually described by this transfer rate. Because the CAS latency is specified in clock cycles, and not transfers (which occur on both the rising and falling edges of the clock), it is important to ensure it is the clock rate (half of the transfer rate) which is being ...