When.com Web Search

  1. Ads

    related to: installing direct vent water heater 40 gallon gas

Search results

  1. Results From The WOW.Com Content Network
  2. Water heating - Wikipedia

    en.wikipedia.org/wiki/Water_heating

    In the United States, typical natural gas water heaters for households without unusual needs are 150–190 L (40–50 US gal) with a burner rated at 10.0–11.7 kilowatts (34,000–40,000 BTU/h). This is a popular arrangement where higher flow rates are required for limited periods.

  3. Storage water heater - Wikipedia

    en.wikipedia.org/wiki/Storage_water_heater

    Solar heat is clean and renewable. This is the most modern system. Increasingly, solar powered water heaters are being used. Their solar thermal collectors are installed outside dwellings, typically on the roof or walls or nearby, and the potable hot water storage tank is typically a pre-existing or new conventional water heater, or a water heater specifically designed for solar thermal.

  4. Direct vent fireplace - Wikipedia

    en.wikipedia.org/wiki/Direct_vent_fireplace

    A direct vent fireplace is a prefabricated metal fireplace that employs a direct-vent combustion system. "Direct vent" refers to a sealed-combustion system in which air for combustion is drawn from the outdoors, and waste combustion gasses are exhausted to the outdoors. "Direct vent" does not simply mean that all gasses from combustion are ...

  5. Heating, ventilation, and air conditioning - Wikipedia

    en.wikipedia.org/wiki/Heating,_ventilation,_and...

    Heaters are appliances whose purpose is to generate heat (i.e. warmth) for the building. This can be done via central heating. Such a system contains a boiler, furnace, or heat pump to heat water, steam, or air in a central location such as a furnace room in a home, or a mechanical room in a large building.

  6. Fixture unit - Wikipedia

    en.wikipedia.org/wiki/Fixture_unit

    A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...

  7. Plumbing - Wikipedia

    en.wikipedia.org/wiki/Plumbing

    Due to its toxicity, most cities moved away from lead water-supply piping by the 1920s in the United States, [36] although lead pipes were approved by national plumbing codes into the 1980s, [37] and lead was used in plumbing solder for drinking water until it was banned in 1986. [36] Drain and vent lines are made of plastic, steel, cast iron ...

  1. Ads

    related to: installing direct vent water heater 40 gallon gas