Ads
related to: lumber grade #2 vs stud gauge diameter table top wood
Search results
Results From The WOW.Com Content Network
The Log Scaler measures the cut trees to determine the scale (volume) and quality (grade) of the wood to be used for manufacturing. When logs are sold, in order to determine the basis for a sale price in a standard way, the logs are "scaled" which means they are measured, identified as to species, and deductions for defects assigned to produce ...
Interior loadbearing walls are framed in the same way as exterior walls. Studs are usually 1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in (38 mm × 89 mm) lumber spaced at 16 in (410 mm) on center. This spacing may be changed to 12 or 24 in (300 or 610 mm) depending on the loads supported and the type and thickness of the wall finish used.
The timber would be typically called battens (7 inches wide), deals (above 7, usually 9 inches wide) and planks (11 inches wide); boards were under 2 inches thick. [3] [4] The standard hundred of the Russian capital of Saint Petersburg was 120 boards which were 12 feet long, 1 1 ⁄ 2 inches thick and 11 inches wide – a volume of 165 cubic ...
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.
In 1961, at a meeting in Scottsdale, Arizona, the Committee on Grade Simplification and Standardization agreed to what is now the current U.S. standard: in part, the dressed size of a 1-inch (nominal) board was fixed at 3 ⁄ 4 inch; while the dressed size of 2 inch (nominal) lumber was reduced from 1 + 5 ⁄ 8 inch to the current 1 + 1 ⁄ 2 inch.
The wood is categorized as a board if its width is less than 2 + 1 ⁄ 2 in (64 mm), and its thickness is less than 1 + 1 ⁄ 2 in (38 mm). A plank used in a building as a horizontal supporting member that runs between foundations, walls, or beams to support a ceiling or floor is called a joist.
When testing wood in lumber form, the Janka test is always carried out on wood from the tree trunk (known as the heartwood), and the standard sample (according to ASTM D143) is at 12% moisture content and clear of knots. [3] The hardness of wood varies with the direction of the wood grain. Testing on the surface of a plank, perpendicular to the ...
A plate in timber framing is "A piece of Timber upon which some considerable weight is framed...Hence Ground-Plate...Window-plate [obsolete]..." etc. [1] Also called a wall plate, [2] raising plate, [3] or top plate, [4] An exception to the use of the term plate for a large, load-bearing timber in a wall is the bressummer, a timber supporting a wall over a wall opening (see also: lintel).