Ads
related to: wire size capacity chart calculator feet and meters
Search results
Results From The WOW.Com Content Network
Wire Gauge to Diameter—Diameter to Wire Gauge Converter - Online calculator converts gauge to diameter or diameter to gauge for any wire size. Calculation: round electric cable diameter to circle cross-sectional area and vice versa; Wire gauge conversion chart
However, AWG is dissimilar to IEC 60228, the metric wire-size standard used in most parts of the world, based directly on the wire cross-section area (in square millimetres, mm 2). The AWG tables are for a single, solid and round conductor. The AWG of a stranded wire is determined by the cross-sectional area of the equivalent solid conductor.
Comparison of SWG (red), AWG (blue) and IEC 60228 (black) wire gauge sizes from 0.03 to 200 mm² to scale on a 1 mm grid – in the SVG file, hover over a size to highlight it. In engineering applications, it is often most convenient to describe a wire in terms of its cross-section area, rather than its diameter, because the cross section is directly proportional to its strength and weight ...
For example, one common wire size used in the NEC has a conductor diameter of 0.5 inches, or 500 mils, and thus a cross-section of = circular mils, written as 250 kcmil or 250 MCM, which is the first size larger than 0000 AWG used within the NEC.
A table of the gauge numbers and wire diameters is shown below. [1] [2] The basis of the system is the thou (or mil in US English), or 0.001 in. Sizes are specified as wire diameters, stated in thou and tenths of a thou (mils and tenths). The wire diameter diminishes with increasing size number.
One brass is exactly 100 square feet (9.29 m 2) area (used in measurement of work done or to be done, such as plastering, painting, etc.). The same word is used, however, for 100 cubic feet (2.83 m 3) of estimated or supplied loose material, such as sand, gravel, rubble, etc
When used for 10/100/1000BASE-T, the maximum allowed length of a Cat 6 cable is 100 meters (328 ft). This consists of 90 meters (295 ft) permanent link, which is typically solid horizontal cabling between two connectors, often the patch panel and the wall jack, plus 10 meters (33 ft) total of stranded patch cordage. [14]
The maximum length for a cable segment is 100 meters (330 ft) per TIA/EIA 568-5-A. [31] If longer runs are required, the use of active hardware such as a repeater or switch is necessary. [ 32 ] [ 33 ] The specifications for 10BASE-T networking specify a 100-meter length between active devices. [ 34 ]