Search results
Results From The WOW.Com Content Network
A roller brake tester is a method of allowing the dynamic assessment of the braking system of a motor vehicle, whilst the vehicle itself is in a static condition.This type of brake tester is normally used in UK garages when used as part of an inspection lane for the MOT test.
The length of the braking test track at the Aldenhoven Testing Center is 150 m, which contains an asphalt and a ceramic pavement lane. Both lanes are 4 m wide and may be wetted as preferred. The braking test lane is surrounded on both sides by a safety zone. A 200 m access acceleration lane is also part of the braking test track. [3]
A Roller Brake is a modular cable-operated drum brake manufactured by Shimano for use on specially splined front and rear hubs. Unlike a traditional drum brake, the Roller Brake can be easily removed from the hub. Some models contain a torque-limiting device called a power modulator designed to make it difficult to skid the wheel.
The purpose is to reduce failures in hydraulic braking systems of motor vehicles which may occur because of the manufacture or use of improper or contaminated fluid. The standard applies to all fluid use of passenger cars, multipurpose passenger vehicles, trucks, buses, trailers and motorcycles equipped with a hydraulic brake system. [1]
Braking distance refers to the distance a vehicle will travel from the point when its brakes are fully applied to when it comes to a complete stop. It is primarily affected by the original speed of the vehicle and the coefficient of friction between the tires and the road surface, [Note 1] and negligibly by the tires' rolling resistance and vehicle's air drag.
Discover the latest breaking news in the U.S. and around the world — politics, weather, entertainment, lifestyle, finance, sports and much more.
The brake balance or brake bias of a vehicle is the distribution of brake force at the front and rear tires, and may be given as the percentage distributed to the front brakes (e.g. 52%) [1] or as the ratio of front and rear percentages (e.g. 52/48). [2]
The concept of brake pads or disc brakes as an alternative to drum brakes had been around at least as early as a patent by F. W. Lanchester in 1902. [2] However, due to high cost and inefficiencies compared to drum brakes they were not commonly implemented until after World War II. [3]