Search results
Results From The WOW.Com Content Network
Subthreshold leakage in an nFET. Subthreshold conduction or subthreshold leakage or subthreshold drain current is the current between the source and drain of a MOSFET when the transistor is in subthreshold region, or weak-inversion region, that is, for gate-to-source voltages below the threshold voltage.
In the subthreshold region, the drain current behaviour—though being controlled by the gate terminal—is similar to the exponentially decreasing current of a forward biased diode. Therefore, a plot of drain current versus gate voltage with drain, source , and bulk voltages fixed will exhibit approximately log-linear behaviour in this MOSFET ...
DIBL also affects the current vs. drain bias curve in the active mode, causing the current to increase with drain bias, lowering the MOSFET output resistance. This increase is additional to the normal channel length modulation effect on output resistance, and cannot always be modeled as a threshold adjustment.
MOSFET drain current vs. drain-to-source voltage for several values of ; the boundary between linear (Ohmic) and saturation (active) modes is indicated by the upward curving parabola. Cross section of a MOSFET operating in the linear (Ohmic) region; strong inversion region present even near drain.
Cross section of a MOSFET operating in the saturation region. Channel length modulation (CLM) is an effect in field effect transistors, a shortening of the length of the inverted channel region with increase in drain bias for large drain biases. The result of CLM is an increase in current with drain bias and a reduction of output resistance.
For a typical current of 10 mA, g m ≈ 385 mS. The input impedance is the current gain (β) divided by the transconductance. The output (collector) conductance is determined by the Early voltage and is proportional to the collector current. For most transistors in linear operation it is well below 100 μS.
In most circuits, this means pulling an enhancement-mode MOSFET's gate voltage towards its drain voltage turns it on. In a depletion-mode MOSFET, the device is normally on at zero gate–source voltage. Such devices are used as load "resistors" in logic circuits (in depletion-load NMOS logic, for example).
IRLZ24N Power MOSFET in a TO-220AB through-hole package. Pins from left to right are: gate (logic-level), drain, source. The top metal tab is the drain, same as pin 2. [1]A power MOSFET is a specific type of metal–oxide–semiconductor field-effect transistor (MOSFET) designed to handle significant power levels.