Search results
Results From The WOW.Com Content Network
Tone control is a type of equalization used to make specific pitches or frequencies in an audio signal softer or louder. It allows a listener to adjust the tone of the sound produced by an audio system to their liking, for example to compensate for inadequate bass response of loudspeakers or earphones, tonal qualities of the room, or hearing impairment.
In switching-mode power supplies , noise present in the control loop circuitry of the supply causes dislocation in up-slope and down-slope timing of the saw-tooth ripple waveform. As a consequence, the ripple waveform exhibits jitter and noise carried on the ripple also jitters. When this type of supply bias is used to power a system operating ...
Audio feedback can create unwanted loud, screaming noises that are disruptive to the performance, and can damage speakers and performers' and audience members' ears. Audio feedback from microphones occurs when a microphone is too near a monitor or main speaker and the sound reinforcement system amplifies itself.
Fig. 2. EMI noise of output voltage for programmed switching frequency (PWM): a) Spectrum and b) Spectrogram. PWM is considered the most common deterministic technique. Considering the example of a DC-DC converter, a controlled switch is designed to “cut-off” the DC waveform into a pulse-shaped waveform.
A distribution board (also known as panelboard, circuit breaker panel, breaker panel, electric panel, fuse box or DB box) is a component of an electricity supply system that divides an electrical power feed into subsidiary circuits while providing a protective fuse or circuit breaker for each circuit in a common enclosure.
The squelch control adjusts the gain of an amplifier which varies the level of the noise coming out of the filter. This noise is rectified , producing a DC voltage when noise is present. The presence of continuous noise on an idle channel creates a DC voltage which turns the receiver audio off.
The amplifying devices in audio and radio equipment are vulnerable to a variety of feedback problems, which can cause distinctive noise in the output. The term motorboating is applied to oscillations whose frequency is below the range of hearing, from 1 to 10 hertz , [ 3 ] so the individual oscillations are heard as pulses.
An analogue switch: Maxim MAX313. An analogue switch, also called a bilateral switch, is an electronic component that behaves in a similar way to a relay, but has no moving parts. The switching element is normally a pair of MOSFET transistors, one an N-channel device, the other a P-channel device. The device can conduct analog or digital ...