Ads
related to: what is a firewire card for printer
Search results
Results From The WOW.Com Content Network
FireWire can connect up to 63 peripherals in a tree or daisy-chain topology [17] (as opposed to Parallel SCSI's electrical bus topology). It allows peer-to-peer device communication — such as communication between a scanner and a printer — to take place without using system memory or the CPU. FireWire also supports multiple host controllers ...
Printer cable refers to the cable that carries data between a computer and a printer. There are many different types of cables, for example: Serial: RS-232, EIA-422; Parallel; FireWire; USB; Parallel port printers have been slowly phased out, and are now difficult to find for the most part, being considered as an obsolete legacy port on most ...
Open Host Controller Interface (OHCI) [1] is an open standard.. Die shot of a VIA VT6307 Integrated Host Controller used for IEEE 1394A communication. When applied to an IEEE 1394 (also known as FireWire; i.LINK or Lynx) card, OHCI means that the card supports a standard interface to the PC and can be used by the OHCI IEEE 1394 drivers that come with all modern operating systems.
Computer ports in common use cover a wide variety of shapes such as round (PS/2, etc.), rectangular (FireWire, etc.), square (Telephone plug), trapezoidal (D-Sub — the old printer port was a DB-25), etc. There is some standardization to physical properties and function.
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.
This is a list of interface bit rates, is a measure of information transfer rates, or digital bandwidth capacity, at which digital interfaces in a computer or network can communicate over various kinds of buses and channels.
The printer responded by pulling the BUSY line high, printing the character, and then returning BUSY to low again. The host could then send another character. Control characters in the data caused other actions, like the CR or EOF. The host could also have the printer automatically start a new line by pulling the AUTOFEED line high, and keeping ...
SCSI-1 card with an external Centronics port which requires a terminator, from an Acorn computer. Old Macintosh DB-25 SCSI port (narrow) Apple used DB-25 connectors, which, having only 25 pins rather than 50, were smaller and less expensive to make, but decreased signal integrity (increasing crosstalk ) [ citation needed ] and cannot be used ...