Ads
related to: radial piston pump stroke
Search results
Results From The WOW.Com Content Network
The stroke of each piston is caused by an eccentric drive shaft or an external eccentric tappet (e.g., stroke ring). When filling the workspace of the pumping pistons from "inside" (e.g., over a hollow shaft) it is called an inside impinged (but outside braced) radial piston pump (picture 1). If the workspace is filled from "outside" it's ...
Piston pump compared to a plunger pump. A piston pump is a type of positive displacement pump where the high-pressure seal reciprocates with the piston. [1] Piston pumps can be used to move liquids or compress gases. They can operate over a wide range of pressures. High pressure operation can be achieved without adversely affecting flow rate.
Fluid flow in an external gear pump. A hydraulic pump is a mechanical source of power that converts mechanical power into hydraulic energy (hydrostatic energy i.e. flow, pressure). Hydraulic pumps are used in hydraulic drive systems and can be hydrostatic or hydrodynamic. They generate flow with enough power to overcome pressure induced by a ...
Packard DR-980 diesel radial aircraft engine A Nordberg Manufacturing Company two-stroke diesel radial engine for power generation and pump drive purposes. While most radial engines have been produced for gasoline, there have been diesel radial engines. Two major advantages favour diesel engines — lower fuel consumption and reduced fire risk.
The axial piston pump drives a series of pistons aligned parallel with a shaft through a swashplate to pump a fluid. [4] A common example of a swashplate application in a fluid pump is the compressor of a present-day automobile air conditioning system. By varying the angle of the swashplate, the pistons' stroke (and, therefore, the compressor's ...
The Pratt & Whitney Wasp was the civilian name of a family of air-cooled radial piston engines developed in the 1920s, 1930s and 1940s. [1]The Pratt & Whitney Aircraft Company (P&W) was founded in 1925 by Frederick B. Rentschler, who had previously been the President of Wright Aeronautical.
Cutaway side-view diagram of an axial piston pump 3-D rendering of an axial piston pump with the parts labeled Animation of an axial piston pump in operation. An axial piston pump has a number of pistons (usually an odd number) arranged in a circular array within a housing which is commonly referred to as a cylinder block, rotor or barrel.
The pump is similar to that of a radial piston-type pump, but instead of a piston it has a machined plunger that has no seals. When the plunger is at top dead center , the injection to the cylinder is finished and it is returned on its downward stroke by a compression spring.