Search results
Results From The WOW.Com Content Network
The UVCH (under valve cover harness) was prone to losing contact with either glow plugs or injectors which caused rough starts or a misfire depending on the year. 1994–1997 engines have two connectors going into each bank, whereas 1999–2003 engines had one connector going into each bank; troubleshooting the harness was easier for the 1994 ...
One unusual feature of the ISB is that it is a multi-valve pushrod engine design, with four valves per cylinder (popularly referred to as the "24-Valve" Cummins). The engine displaces 5.9 L; 359.0 cu in (5,883 cc), with a 102 mm × 120 mm (4.02 in × 4.72 in) cylinder bore and piston stroke.
The timing, duration and lift of these valve events has a significant impact on engine performance. Without variable valve timing (variable valve lift), the valve timing is the same for all engine speeds and conditions, therefore compromises are necessary to achieve the desired result in intake and exhaust efficiency . This has been described ...
A compression release engine brake, compression brake, or decompression brake is an engine braking mechanism installed on some diesel engines. When activated, it opens exhaust valves to the cylinders, right before the compression stroke ends, releasing the compressed gas trapped in the cylinders, and slowing the vehicle. Clessie Cummins was ...
An exhaust brake is a means of slowing a diesel engine by closing off the exhaust path from the engine, causing the exhaust gases to be compressed in the exhaust manifold, and in the cylinder. Since the exhaust is being compressed, and there is no fuel being applied, the engine slows down the vehicle: the crankshaft (and, hence, the wheels ...
Other important differences between the Vortec 8100 and older big-blocks include a changed firing order. The firing order of older big-block engines is 1-8-4-3-6-5-7-2 [62] while Vortec 8100's firing order is 1-8-7-2-6-5-4-3. Other upgrades of Vortec 8100 include a new 18-bolt head bolt pattern, longer connecting rods, different symmetrical ...
Wet stacking is a condition in diesel engines in which unburned fuel passes on into the exhaust system. [1] The word "stacking" comes from the term "stack" for exhaust pipe or chimney stack. The oily exhaust pipe is therefore a "wet stack". This condition can have several causes.
The hemi head always has intake and exhaust valve stems that point in different directions, requiring a large, wide cylinder head and complex rocker arm geometry in both cam-in-block and single overhead cam engines (dual overhead cam engines may not have rocker arms). This adds to the overall width of the engine, limiting the vehicles in which ...