Search results
Results From The WOW.Com Content Network
fishtailing, where the vehicle yaws back and forth across the direction of motion. spin or spinout where a vehicle rotates in one direction during the skid. understeer and oversteer where front or rear wheels lose traction during cornering, causing a vehicle to follow a larger or smaller turning radius.
Fishtailing is a vehicle handling problem which occurs when the rear wheels lose traction, resulting in oversteer. This can be caused by low- friction surfaces (sand, gravel, rain, snow, ice, etc.). Rear-drive vehicles with sufficient power can induce this loss of traction on any surface, which is called power-oversteer .
It is thus always recommended to install dry-running protection on all booster sets. There are three different methods for detection of water shortage: Pressure switch on suction manifold or float switch/electrode relay in the supply tank: Dry-running protection with pressure/level switch.
Uses of pneumatic pressure switches include: Switch a household well water pump automatically when water is drawn from the pressure tank. Switching off an electrically driven gas compressor when a set pressure is achieved in the reservoir; Switching off a gas compressor, whenever there is no feed in the suction stage. in-cell charge control in ...
A diagram of an aquaplaning tire Two vehicles aquaplaning through large puddles on the road's surface. Aquaplaning or hydroplaning by the tires of a road vehicle, aircraft or other wheeled vehicle occurs when a layer of water builds between the wheels of the vehicle and the road surface, leading to a loss of traction that prevents the vehicle from responding to control inputs.
When a trailer skids to one side, this is known as a trailer swing or trailer slew.This can occur on a slippery road surface, often where there is a cant.This is not the same as jackknifing and is not as serious, as the trailer will move back into line as the vehicle continues forwards.
Installation may involve shrink-fitting, heating the cylinder head and cooling the valve guide so as to ease insertion, then driving the new guide in quickly with a press or a hammer. Once the parts return to room temperature the new valve guide will be solidly in place and ready to be reamed and honed to proper diameter.
The sensor has an input port to measure the hydraulic braking pressure and an electrical connector output for a wire connection for feeding the warning light. Some brake failures do not trip the sensor into a fault mode. A brake fluid pressure sensor is used in anti-lock braking system (ABS). ABS fault lights come on with unexpected wheel lock ...